2000-05 Toyota Celica Mirror - 1AMRE01389

This replacement mirror is just what you need to get your vehicle in good working condition again!

Mirror specifications:

• Fits Passenger side
• Power mirror
• Replaces dealer part number: 879102D110C0
• Injection molded black plastic housing
• Can be painted by the buyer to any color desired or installed as is
• Direct replacement
• Built to strict quality control standards

This mirror makes a great replacement and has good cost savings over a dealer part.

Special Note:

• Unless otherwise noted, replacement mirrors will only work properly on vehicles with the exact same options. If your vehicle does not have the options listed in specifications, the mirror(s) may not function properly.

Item Condition: New

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

step : Removing the Door Panel (0:36)

• Pry off the mirror base trim piece with a flat blade screwdriver
• Remove the two tabs on the door panel with a flat blade screwdriver
• Pry off the trim piece inside the door handle with a flat blade screwdriver
• Remove the Phillips screw inside the door handle
• Remove the two Phillips screws on the door panel
• Remove the three Phillips screws on the bottom of the door panel
• Pry up the power mirror switch with a flat blade screwdriver
• Disconnect the mirror switch harness
• Pry out the door panel
• Lift the door panel up and off
• Disconnect the latch cables from the door handle

step : Removing the Rear View Mirror (2:25)

• Disconnect the mirror wiring harness
• Remove the three 10mm bolts holding the mirror
• Remove the Phillips screw holding the mirror in
• Remove the Mirror

step : Installing the Rear View Mirror (3:28)

• Remove the Phillips screw from the new mirror
• Insert the new mirror into place
• Insert and tighten the four Phillips screws
• Reconnect the mirror harness

step : Installing the Door Panel (4:08)

• Connect the latch cables to the door handle
• Lift the door panel into place
• Push in the door panel clips
• Connect the mirror switch harness
• Insert the power mirror switch into place
• Insert and tighten the three Phillips screws on the bottom of the door panel
• Insert and tighten the two Phillips screws on the door panel
• Insert and tighten the Phillips screw into the door handle
• Insert the trim piece inside the door handle
• Insert the two tabs on the door panel
• Push in the mirror base trim piece