2000-05 Toyota Celica Interior Door Handle - 1ADHI00452

This inside door handle is just what you need to get your vehicle in good looking form again!

Specifications:

• RH (Passenger Side)
• Replaces dealer part number: 69205-20180-CO, 6920520180C0
• Chrome Finish
• Direct replacement
• Built to strict quality control standards

This inside door handle is a great replacement and has good cost savings over the dealer unit.

Item Condition: New

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

step : Removing the Door Panel (0:37)

• Pry off the mirror base trim piece with a flat blade screwdriver
• Remove the two tabs on the door panel with a flat blade screwdriver
• Pry off the trim piece inside the door handle with a flat blade screwdriver
• Remove the Phillips screw inside the door handle
• Remove the two Phillips screws on the door panel
• Remove the three Phillips screws on the bottom of the door panel
• Pry up the power mirror switch with a flat blade screwdriver
• Disconnect the mirror switch harness
• Pry out the door panel
• Lift the door panel up and off
• Disconnect the latch cables from the door handle

step : Removing the Door Handle (2:22)

• Remove the Phillips screw from the door handle
• Remove the door handle

step : Installing the New Door Handle (2:46)

• Insert the new door handle into the door panel
• Insert and tighten the Phillips screw into the door handle

step : Reinstalling the Door Panel (3:03)

• Connect the latch cables to the door handle
• Lift the door panel into place
• Push in the door panel clips
• Connect the mirror switch harness
• Insert the power mirror switch into place
• Insert and tighten the three Phillips screws on the bottom of the door panel
• Insert and tighten the two Phillips screws on the door panel
• Insert and tighten the Phillips screw into the door handle
• Insert the trim piece inside the door handle
• Insert the two tabs on the door panel
• Push in the mirror base trim piece