Replaces

2000-05 Chevy Impala Monte Carlo Power Window Switch - 1AWES00064

This replacement power window switch is just what you need to get the power windows working again in your vehicle.

Specifications:

  • Fits RH (Passenger Side) FRONT
  • Direct replacement
  • Built to strict quality control standards

Replace your broken window switch now with this great fitting alternative. It makes a great replacement and has good cost savings over a dealer unit.

Our electrical and electronic parts are subject to strict quality control testing.  Once the item has been installed or plugged in, it is no longer eligible for a refund.  The item may be eligible for replacement, only if it is found to have a manufacturing defect. Before purchasing, please ensure proper diagnosis of the failed original part is performed

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. step : Removing the Door Panel (0:37)
    • Remove the Phillips head screw at the front top corner of the door panel
    • Remove the Phillips head screw inside the door handle
    • Remove the two T25 Torx screws under the pull handle
    • Pry off the trim piece inside the door handle with a flat blade screwdriver
    • Pry off the door lock switch while pulling up with a flat blade screwdriver
    • Slide a putty knife into the side of the door panel and pry out on the clip
    • Pull out sharply to release the clips around the door panel
    • Lift the door panel up and pull it back
    • Pull the speaker and switch panel harnesses free
  2. step : Disconnecting the Power Window Switch (2:07)
    • Remove the three Phillips screws holding on the plate
    • Remove the Phillips screw from the pull handle
    • Push in the clip switch panel clips with a flat blade screw driver
    • Pry the switch clips and remove the switch from the panel
  3. step : Installing the New Power Window Switch (3:22)
    • Put the new switch into the switch panel
    • Push the outside of the switch panel in first, then the front, inside, and back
    • Tighten the Phillips screw on the pull handle
    • Replace the three Phillips screws on the plate
  4. step : Reinstalling the Door Panel (4:03)
    • Reconnect the speaker harness and switch pack harnesses
    • Put the door panel down into the window sill
    • Lineup and re-clip the door panel
    • Reconnect the door lock switch into the door handle panel
    • Replace the trim piece inside the door handle
    • Tighten the Phillips head screw at the front top corner of the door panel
    • Tighten the Phillips head screw inside the door handle
    • Tighten the two T25 Torx screws under the pull handle

Tools needed for replacement:

    General Tools

  • Putty Knife

  • Screwdrivers & Related

  • Phillips Head Screwdriver
  • Flat Blade Screwdriver

  • Torx Drivers & Sockets

  • T25 Torx Driver

5.0 / 5.0
1 Review
5 Stars
4 Stars
3 Stars
2 Stars
1 Stars
1
0
0
0
0
Works great
My passenger door window switch was not working. Purchased this item from 1A Auto and watched their video for installation. Followed the video directions and the switch worked as described.
Thank you.
April 4, 2018
Purchased
1 month ago
Start typing your question and we'll check if it was already asked and answered. Learn More
Browse 1 question Browse 1 question and 1 answer
MY IMPALA HAS ALL 4 DOOR WINDOW ON THE DOOR TO PUSH UP OR DOWN YOU SHOW ONE 2003 iMPALA?
PHIL F on Jun 8, 2017
BEST ANSWER: At this time we do not offer the specific switch you are looking for. This switch is just for the passenger side operation.

Vehicle Fit

  • 2000-2005 Chevy Impala Power Window Switch Front Passenger Side
  • 2000-2005 Chevy Monte Carlo Power Window Switch Passenger Side

This part replaces:

  • OE # 10308318
  • OE # 19244646
  • Dorman 901-145
  • Standard Motor Products DWS-287
Part #: 1AWES00064

Out of Stock

How-to Video:

(05:40 min)