Replaces

2000-05 Chevy Impala Monte Carlo Headlight Switch - 1AZHS00235

Description
Warranty & Shipping
How-To & Tools
Product Reviews
Q&A
Vehicle Fit

This headlight switch is a new, aftermarket replacement part. It is designed to REPLACE original units that are prone for failure. It's just what you need to get your vehicle in good working order again!

Specifications:

  • Controls the following functions:
    • Headlights
    • Parking lights
  • Replaces dealer part numbers: 10406799
  • Dash Mounted
  • Exact replacement
  • Design improved for more durability
  • Built to strict quality control standards
  • Correct for models with Fog Lights
  • Does not fit Police Models

This headlight switch makes great replacement and has good cost savings over a dealer unit.

Our electrical and electronic parts are subject to strict quality control testing. Please ensure proper diagnosis of this item before purchasing as the item cannot be returned once installed or plugged in.

Item Condition: New

WARNING:  This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

  1. step : Removing the Lower Dash Panel (0:34)
    • Press the tabs on the lower panel beneath the steering wheel and pull it down
    • Twist the socket free from the panel
    • Remove the bulb from the socket
    • Remove the two 7mm bolts from the dash trim panel
    • Unclip and pull the dash trim panel
    • Remove the trunk switch harness with a flat blade screwdriver
  2. step : Removing the Steering Wheel Panel (1:27)
    • Lift up the steering wheel
    • Remove the T25 screw underneath the steering wheel
    • Pry out on the steering wheel lever
    • Pull the lower steering wheel panel down and out
    • Remove the E5 External Torx bolts from below the steering wheel
    • Pull the upper steering wheel panel up and off
  3. step : Removing the Dash Trim Panel (2:28)
    • Unclip and pull out the fuse panel door
    • Remove the 7mm bolt from the dash trim panel with a socket and ratchet
    • Open the glove compartment and remove the 7mm bolt from the dash trim panel
    • Pry off the ignition bezel with a flat blade screwdriver
    • Pull out and unclip either side of the dash panel
    • Pull the dash panel forward
    • Use a flat blade screwdriver to disconnect the hazard switch without breaking the bezel
    • Turn the car on
    • Pull the shifter back all the way
    • Pull the dash panel up and out
  4. step : Removing the Headlight Switch (4:10)
    • Remove the three 7mm bolts from the headlight switch
    • Pull the switch out and pry out the headlight switch harness with a flat blade screwdriver
  5. step : Installing the New Headlight Switch (5:02)
    • Reinstall the headlight switch harness
    • Replace and tighten the three 7mm bolts on the headlight switch
  6. step : Reinstalling the Dash Trim Panel (5:38)
    • Open the glove compartment
    • Turn the car on
    • Pull the shifter back all the way
    • Pull the steering wheel down
    • Line up the dash trim panel
    • Reconnect the hazard switch
    • Slide the shifter forward and remove the key
    • Re-clip the dash panel
    • Replace and tighten the 7mm bolts into the dash trim panel
    • Replace the ignition bezel
  7. step : Reinstalling the Steering Wheel Panel (7:02)
    • Tilt the steering wheel down
    • Reconnect the upper steering wheel panel
    • Replace and tighten the E5 External Torx bolts
    • Re-clip the hooks on the lower panel push it up until it clicks
    • Replace and tighten the T25 Torx screw
  8. step : Reinstalling the Lower Dash Panel (8:00)
    • Reconnect the trunk switch harness
    • Push the dash trim panel into place
    • Replace and tighten the 7mm bolts
    • Twist the bulb into the socket on the panel
    • Push the lower panel into place beneath the steering wheel until it clicks

Tools needed for replacement:

    Ratchets & Related

  • Ratchet

  • Screwdrivers & Related

  • Flat Blade Screwdriver

  • Sockets - Metric

  • 7mm Socket

  • Torx Drivers & Sockets

  • T25 Torx Driver
  • E5 Inverted Torx Socket

5.00/ 5.0
1review
5 Stars
4 Stars
3 Stars
2 Stars
1 Star
1
0
0
0
0
Reliable Headlight Switch
This is a great purchase. After pricing this product from local automotive stores, your price cant be beat! The part was easy to replace and fits perfectly. Now my husbands Impala can keep going. We are reaching 200,000 miles and want to keep going!!!
September 18, 2017
Will this fit my car? Add a vehicle to make sure
Customer Q&A
Ask a question to 1A Auto customers who purchased the product
Would it also replace part # 10283776 ?
Javier G April 11, 2018
The part only replaces 10406799.
Tim K April 11, 2018
Year Make Model Description
2000-2005Chevy Impala Chevy Impala (excluding Police Package) Headlight Switch for Models with Fog Lights
2000-2005Chevy Monte Carlo Chevy Monte Carlo Headlight Switch for Models with Fog Lights
Part #: 1AZHS00235


Order must be placed by 4pm ET

Get it in: 2 - 4 Business Days

Want it sooner? Choose Next Day Air at Checkout

How-to Video:

(09:24 min)