1999-04 Oldsmobile Alero Tail Light - 1ALTL00397

This replacement Tail light is just what you need to get your Oldsmobile Alero in good looking form again!

Specifications:

• LH (Driver Side)
  • Mounted on quarter panel
• DOT (Department of Transportation) & SAE (Society of Automotive Engineers) approved
• Direct replacement
• Built to strict quality control standards
• Red and Amber in color as original

We have noticed that there are many inferior quality Tail lights on the market. We have researched other tail light manufacturers and are only selling what we believe to be the highest quality, best fitting, aftermarket tail lights available. So don't be fooled by cheaper made imitation tail lights. Go with superior quality!

This light makes a great replacement and has good cost savings over a dealer unit.

Bulb Note:

Unless otherwise noted, our lights do not include bulbs, though occasionally lighting manufacturers do include bulbs in the lights. If you happen to receive a lighting product (Headlight, Tail light, parking light, fog light etc.) that comes with the bulbs, the bulbs are not covered under our warranty. Our warranty applies only to the light assembly.

Direct fit replacement for OEM assembly

Uses same wiring as original assembly.  No cutting or splicing required.

Meets federal regulations for on-road use

Item Condition: New

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

step : Removing the Taillight Assembly (0:35)

• Lift the panel along the trunk up and off.
• Remove the cargo clip.
• Pull back the insulation.
• Remove the three thumb screws.
• Pull the taillight assembly straight out.
• Unclip the harness from the taillight.
• Twist all of the sockets out.
• To change a bulb pull it straight out and push the new bulb in.

step : Replacing the Taillight Assembly (2:28)

• Twist the sockets into the new taillight assembly.
• Clip the harness back into place.
• Line up the taillight and push it into place.
• Replace the three thumb screws.
• Replace the insulation and net clip.
• Push the panel down into place.