1999-01 Jeep Grand Cherokee Heater Blower Motor with Fan Cage - 1AHCX00090

This Jeep Grand Cherokee blower motor with fan cage is a new, aftermarket replacement part. It is just what you need to bring your heating and A/C blower system back to good working order! This assembly has the following


  • New, not remanufactured or rebuilt
  • Includes blower motor fan cage impeller already installed
  • Direct replacement
  • Replaces dealer part numbers: 5015860AA
  • Built to strict quality control standards
  • 100% tested prior to leaving the factory

If you are experiencing intermittent stopping during use, squealing noise from bearings, or poor air flow from your dash vents this may be your solution.

Returns Note:

Our electrical and electronic parts are subject to strict quality control testing.  Once the item has been installed or plugged in, it is no longer eligible for a refund.  The item may be eligible for replacement, only if it is found to have a manufacturing defect. Before purchasing, please ensure proper diagnosis of the failed original part is performed.

Left Hand Drive Note:

“All of our auto parts are intended for Left Hand Drive USDM vehicles and might not have been tested on Right Hand Drive platforms. If your vehicle is Right Hand Drive, please do your research prior to making a purchase to ensure the part is correct for your specific vehicle.”

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

  1. step : Removing the Fan Motor Resistor (0:52)
    • Open the glove box
    • Remove any items inside the glove box
    • Push the glove box walls in
    • Pull down the glove box
    • Disconnect the fan motor resistor wiring harnesses
    • Remove the two 8mm bolts from the resistor
    • Pull out the resistor
  2. step : Installing the New Fan Motor Resistor (1:48)
    • Push the new resistor into place
    • Insert the two 8mm bolts into the resistor
    • Connect the wiring harnesses to the resistor
    • Raise the glove box into place
    • Push the glove box walls in
    • Push the glove box into place
    • Close the glove box

Tools needed for replacement:

    General Tools

  • Flashlight

  • Ratchets & Related

  • Socket Extensions
  • Ratchet

  • Sockets - Metric

  • 8mm Socket

5.0 / 5.0
1 Review
5 Stars
4 Stars
3 Stars
2 Stars
1 Star
Easy Install
Blower motor with squirrel cage arrived promptly and in good order. Three bolts and and electrical connector and your back in business. This is an easy repair!
October 23, 2017
10 months ago
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 1999-2001 Jeep Grand Cherokee Heater Blower Motor with Fan Cage

This part replaces:

  • Hollander 615-00592
  • OE # 5015860AA
  • TYC 700011
  • DEPO 333-58003-000
Part #: 1AHCX00090

Order must be placed by 4pm ET

How-to Video:

(03:08 min)