This replacement Camshaft Position Sensor / Synchronizer with Alignment Tool is just what you need to get your vehicle in good running condition again!

A bad or malfunctioning cam sensor will often cause a service engine light error code, and or cause a no start condition, or rough running due to inaccurate ignition and fuel timing.


  • Replaces dealer part numbers: XL2Z12A362AA, XL2Z 12A362 AA
  • Direct replacement
  • Alignment tool included
  • Built to strict quality control standards
  • 100% factory tested
  • Fits the following Ford engines as listed per application:
    • V8 5.0L

Returns Note:

Our electrical and electronic parts are subject to strict quality control testing.  Once the item has been installed or plugged in, it is no longer eligible for a refund.  The item may be eligible for replacement, only if it is found to have a manufacturing defect. Before purchasing, please ensure proper diagnosis of the failed original part is performed.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 1999-2001 Ford Explorer Camshaft Position Synchronizer V8 5.0L
  • 1999-2001 Mercury Mountaineer Camshaft Position Synchronizer V8 5.0L

This part replaces:

  • OE # XL2Z12A362AA
  • Standard Motor Products CSA7
  • Dorman 689-101
Part #: 1ACPS00025

Out of Stock