1998-02 Honda Accord Mirror - 1AMRE00148

This replacement mirror is just what you need to get your vehicle in good looking form again!

Specifications:

• Fits the LH (Driver Side)
• Replaces dealer part numbers: 76250-S84-A01, 76250-S84-L01, 76250S84A01, 76250S84L01
• Manual remote operation
• Comes black
  • Can be painted to match by buyer or installed as is
• Direct replacement
• Injection molded plastic housing
• Built to strict quality control standards
• non-folding design
• Correct for 4 door models only
  

This mirror is designed to replace the factory mirror and will install just as the original does. It makes a great replacement that has good cost savings over a dealer part.

Special Note:

• Unless otherwise noted, replacement mirrors will only work properly on vehicles with the exact same options. If your vehicle does not have the options listed in specifications, the mirror(s) may not function properly.

Item Condition: New

Attention California Customers:

WARNING:  This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

step : Remove the door panel (1:00)

• Remove the triangle panel by prying it up with a flat blade screwdriver.
• Unscrew the Phillips screws from the door pull.
• Pull the switch panel.
• Unplug the wiring harness.
• Lift the door panel up and off.
• Disconnect the door latch and lock.
• Unplug all your wiring harnesses.

step : Remove the side mirror (4:00)

• Disconnect the defrost wiring to the mirror.
• Unbolt the 8mm bolts securing the mirror.

step : Install the new side mirror (5:07)

• Plug in the mirror wiring.
• Anchor the mirror by bolting in the 8mm bolts.

step : Install the door panel (6:37)

• Connect the wiring harnesses to the door panel
• Connect the door handle latches
• Lift the door panel into place
• Connect the switch wiring harnesses
• Push in the switch panel
• Insert the Phillips screws into the door pull
• Push on the triangle panel
• For more detailed door panel reassembly instructions, see our other videos.