DORMAN GRAY INSIDE DOOR HANDLE: 79502

This replacement inside door handle is just what you need to get your vehicle in good looking form again!

Specifications:

• Brand New Dorman Inside Door Handle
• Fits LH (Driver Side) FRONT or REAR
• Gray Finish
• Steel center rod and return spring
• Built to strict quality control standards

This inside door handle is a great replacement and has good cost savings over a dealer unit.

This new handle is made to the original color shade.  Due to vehicle age and fading from the sun, our new handles may not match your existing handle or bezel exactly.  If you are looking for an exact match, we recommend replacing handles in pairs or sets.

Item Condition: New

Attention California Customers:

WARNING:  This product can expose you to chemicals including Butyl benzyl phthalate (BBP)d, which is known to the State of California to cause birth defects or other reproductive harm.  For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge.

step : Removing the Inside Door Panel (1:01)

• Remove the Phillips screw from the inside door handle.
• Slide the handle forward and pull it out.
• Disconnect the clip on the back from the rod using a flat blade screwdriver.
• Pry up the switch panel and pull it forward.
• Disconnect the window switch lead.
• Pry up the armrest pad
• Remove the screws from underneath the pad.
• Turn the Phillips head until it pops out.
• Remove the panel by the mirror.
• Remove the side panel.
• Remove the water shield.

step : Removing the Exterior Handle (3:24)

• From the inside of the door, remove the upper yellow clip attached to the handle.
• Use a flat blade screw driver through the smaller hole and push the rod out of the handle.
• Remove the lower yellow clip. And pull the rod out.
• Remove the upper 10 mm bolt from the inside of the handle. Then the one below it.
• From the outside lift the door handle up and pull it free.

step : Installing the New Handle. (6:12)

• Remove the locking mechanism from the old handle and attach it to the new handle.
• While inserting the handle into the door reconnect the lower rod and clip.
• Replace the 10 mm bolts.
• Reattach the upper rod and clip and flip the clip down.
• Line up and reinstall the door panel.
• Reinsert all of the screws and panels.
• Insert the Phillips head clip.