Axle shafts may need replacing for a variety of different reasons. On vehicles that do heavy work or endure other extreme use you can actually break an axle or strip the splines or teeth. More often the bearing wears out and spins on the axle ruining bearing mount surface useless.

Our axles are NEW. They are made to the same specifications in high strength alloy. Shipped to your door.


  • Fits Passenger Side
  • Replaces Jeep part number: 4856332 & 748711X
  • Design Type: C-Clip
  • Length: 29.26 inches
  • Axle Shaft Splines: 30
  • Wheel Stud Provisions: 5
  • Direct fit for Dana Spicer D44 ring gear
  • Built to strict quality control standards
  • Buyer will need to swap over original wheel studs (not included)
  • Only fits Jeep Dana Spicer 44 models

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 1996-1998 Jeep Grand Cherokee Rear Axle Shaft for Dana 44 Axle and Rear Disc Brakes Passenger Side

This part replaces:

  • Hollander 447-2232R
  • OE # 4856332
  • Dorman 630-305
Only 2 left in stock
Part #: 1AAXS00077

Order must be placed by 4pm ET