Replaces

1996-02 Toyota 4Runner Front Heater Blower Motor with Fan Cage - 1AHCX00175

Frequently bought together

Description
Warranty & Shipping
How-To & Tools
Product Reviews
Q&A
Vehicle Fit

This Toyota 4Runner FRONT heater blower motor with fan cage is a new, aftermarket replacement part. It is just what you need to bring your heating and A/C blower system back to good working order! This assembly has the following

Specifications:

  • New, not remanufactured or rebuilt
  • Includes blower motor fan cage impeller already installed
  • Direct replacement
  • Replaces dealer part numbers: 8710335020, 8710335021, 8710335022, 87103-35020, 87103-35021, 87103-35022
  • Built to strict quality control standards
  • 100% tested prior to leaving the factory
  • Fits the FRONT blower motor

If you are experiencing intermittent stopping during use, squealing noise from bearings, or poor air flow from your dash vents this may be your solution.

Our electrical and electronic parts are subject to strict quality testing.

Parts cannot be returned after they have been installed. Contact us with any questions before installing the parts.

Left Hand Drive Note:

“All of our auto parts are intended for Left Hand Drive USDM vehicles and might not have been tested on Right Hand Drive platforms. If your vehicle is Right Hand Drive, please do your research prior to making a purchase to ensure the part is correct for your specific vehicle.”

Item Condition: New

Attention California Customers:

WARNING:  This product can expose you to chemicals including Di(2-ethylhexyl)phthalate (DEHP), which is known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge.

  1. step : Accessing the Blower Motor (0:37)
    • Remove the four Phillips head screws from the door sill plate
    • Remove the sill plate
    • Pry off the kick plate by hand
  2. step : Removing the Blower Motor (1:19)
    • Disconnect the wiring harness from the blower
    • Remove the three screws from the blower with either a T25 Torx Driver or an 8mm socket
    • Pull out the blower
  3. step : Installing the New Blower Motor (2:22)
    • Put the new blower into place with the tab on the left
    • Start the three screws by hand
    • Tighten the three screws
    • Attach the blower motor wiring harness
    • Turn the car on
    • Test the fan
    • Turn the car off
  4. step : Reinstalling the Trim Panels (3:41)
    • Snap the kick panel into place
    • Put the sill plate in place
    • Insert the four Phillips screws into the sill plate

Tools needed for replacement:

    Ratchets & Related

  • Ratchet
  • Socket Extensions

  • Screwdrivers & Related

  • Phillips Head Screwdriver

  • Sockets - Metric

  • 8mm Socket

  • Star Drivers & Sockets

  • T25 Driver

4.00/ 5.0
3 reviews
5 Stars
4 Stars
3 Stars
2 Stars
1 Star
1
1
1
0
0
Heater Blower Motor with Fan Cage
Part was extremely affordable and easy to install. Part overall operates identically to original part. Does have a slight whistle when operating at highest speed, but again overall extremely satisfied to have my fan blower working in order to have A/C during these 110+ summer temps ??
June 21, 2017
Toyota 4Runner A/C blower fan
Ordered this to replace a malfunctioning unit. Fits perfectly and returned the a/c to full functionality. Great customer service.
October 1, 2017
DOA part, Return requested
This fan appeared to fit perfectly, but it died in the first 1/2 second of power up. I just submitted a return request and will follow up with a review of the return process. The part did look identical to the original. I would give it 4 stars if the return goes smooth. Greg
January 1, 2019
Will this fit my car? Add a vehicle to make sure
Customer Q&A
Ask a question to 1A Auto customers who purchased the product
No questions have been asked about this item.
Year Make Model Description
1996-2002Toyota 4Runner Toyota 4Runner Front Heater Blower Motor with Fan Cage
Part 1AHCX00175
In Stock


Order must be placed by 4pm ET
Delivery options for:

Estimated Arrival Cost


Deliveries made to PO Boxes and FPO may take longer. See our Shipping & Delivery for more information.