Replaces

1995-99 Toyota Avalon Window Regulator Pair - 1AWRK00335

Description
Warranty & Shipping
How-To & Tools
Product Reviews
Q&A
Vehicle Fit

Part Details

  • Regulator Option:   with Motor
  • Quantity:   Pair
  • Operation:   Power

These replacement Window Regulators are just what you need to get your vehicle in good shape again!

Specifications:

  • Comes as a PAIR
    • Fits both the LH (Driver Side) & RH (Passenger Side) FRONT DOORS
  • Includes the power window motors
  • Replaces dealer part numbers: 6982007010, 6981007010, 6981007020, 69820-07010, 69810-07010, 69810-07020
  • Built to strict quality control standards
  • Motors and regulators are pre-assembled for easier installation

These Window Regulators make good replacements and have substantial cost savings over the dealer units.

Please Note: These window regulators are high quality aftermarket parts that meets or exceeds the performance of the original. They have been subjected to extensive testing and quality control standards. That is why we offer these regulators with our superior warranty!

Item Condition: New

Attention California Customers:

WARNING:  This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

  1. step : Removing the Door Panel (0:39)
    • Pry off the mirror base trim piece with a flat blade screwdriver
    • Pry off the door handle bezel with a flat blade screwdriver
    • Pry up the window switch panel with a flat blade screwdriver
    • Disconnect the window switch wiring harnesses
    • Pry off the two screw covers at the front edge of the door panel
    • Pry off the screw cover in the door pull
    • Pry the plastic clip out of the rear edge of the door panel
    • Remove the four Phillips screws from the bottom of the door panel
    • Remove the two Phillips screws from the front edge of the door panel
    • Remove the Phillips screw behind the window switch panel
    • Remove the Phillips screw from the door pull
    • Lift the door panel up and off
    • Disconnect the courtesy light wiring harness
    • Carefully peel off the water shield
  2. step : Removing the Window Regulator (3:12)
    • Remove the three Phillips screws from the window regulator panel
    • Remove the 10mm nut from the regulator panel
    • Pull off the panel
    • Disconnect the window motor wiring harness
    • Unclip the wiring harnesses from the regulator track
    • Lift the window by hand
    • Remove the two 10mm bolts that hold the window to the regulator
    • Tilt the window out of the door
    • Remove the two 10mm nuts from the regulator
    • Remove the three 10mm nuts from the window motor
    • Pull the regulator out through the door
  3. step : Installing the Window Regulator (6:58)
    • Slide the regulator into the door
    • Fasten the two 10mm nuts onto the regulator
    • Fasten the three 10mm nuts onto the window motor
    • Tilt the window into the door
    • Lower the window onto the regulator
    • Insert the two 10mm bolts that hold the window to the regulator
    • Connect the window motor wiring harness
    • Hold the harness in place with wire ties
    • Put on the regulator panel
    • Insert the three Phillips screws into the panel
    • Fasten the 10mm nut ont the panel
    • Connect the window switch wiring harnesses
    • Test the window with the switch
    • Disconnect the window switch wiring harness
  4. step : Reinstalling the Door Panel (9:55)
    • Put the water shield into place
    • Connect the courtesy light wiring harness
    • Lift the door panel into place
    • Insert the Phillips screw behind the window switch panel
    • Insert the Phillips screw into the door pull
    • Insert the two Phillips screws at the front edge of the door panel
    • Insert the four Phillips screws at the bottom of the door panel
    • Push on the door pull screw cover
    • Connect the window switch wiring harnesses
    • Push in the window switch panel
    • Push on the door handle bezel
    • Push on the screw covers at the front edge of the door panel
    • Push on the mirror base trim panel
    • Push the plastic clip into the rear edge of the door panel

Tools needed for replacement:

    Materials, Fluids, and Supplies

  • Wire Ties

  • Ratchets & Related

  • Ratchet
  • Socket Extensions

  • Screwdrivers & Related

  • Flat Blade Screwdriver
  • Phillips Head Screwdriver

  • Sockets - Metric

  • 10mm Socket

5.00/ 5.0
1review
5 Stars
4 Stars
3 Stars
2 Stars
1 Star
1
0
0
0
0
1997 toyota avalon window regulators with motor
Have ordered many many parts from 1A Auto, Have never been disappointed yet. Struts,window motors, engine mounts and window regulators. Every single thing has been correct part and fit perfectly. I cant say enough about how pleased I am with the excellent parts that are correct and nice quality. These window regulators all fit correctly, I ordered all four. 180 bucks ""each"" in my area!!! Got all four delivered to my door for 215.. Awesome awesome awesome.. Keep up the good work!! I will always check your site before I buy anything auto related. Thank you!!!!
July 28, 2018
Will this fit my car? Add a vehicle to make sure
Customer Q&A
Ask a question to 1A Auto customers who purchased the product
No questions have been asked about this item.
Year Make Model Description
1995-1999Toyota Avalon Toyota Avalon Front Power Window Regulator with Motor Pair
Only 4 left in stock
Part #: 1AWRK00335


Order must be placed by 4pm ET

Get it in: 2 - 4 Business Days

Want it sooner? Choose Next Day Air at Checkout

How-to Video:

(12:27 min)