This hood latch is a new, aftermarket replacement part. It is just what you need to repair or replace a bent or defective hood latch and bring back the safety and integrity of a safely latched hood.

If, traveling down the highway, the hood latch fails and the safety latch lets go, the hood can actually fly off the vehicle posing a serious hazard to you and anyone behind you. So don't hesitate to replace a questionable hood latch and keep your vehicle safe.

This hood latch has the following specifications:

  • Replaces dealer part numbers: 53510-02020, 5351002020
  • Mounts to radiator support
  • Built to strict quality control standards
  • Not correct for models that came equipped with a Factory Installed Alarm

The hood latch makes a great replacement and has good cost saving over a dealer hood catch.

Note:

It is necessary to reuse your original hardware, as new hardware is not included with this item.

 

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

  1. step : Removing the Hood Latch (1:43)
    • Remove the two 13mm bolts securing the hood latch.
    • Pry the hood latch cable up and out of the hood latch.
  2. step : Replacing the Hood Latch (2:42)
    • Pull back the spring and reconnect the hood latch cable.
    • Line up the hood latch and put it down into place.
    • Replace the two 13mm bolts.
  3. step : Adjusting Hood Height (3:45)
    • Loosen the 13mm bolts and slide the latch up or down to adjust the height of the center.
    • Turn the rubber knobs on either side of the engine to adjust the height of the sides.

Tools needed for replacement:

    Screwdrivers & Related

  • Flat Blade Screwdriver

  • Wrenches - Metric

  • 13mm Wrench

1.0 / 5.0
1 Review
5 Stars
4 Stars
3 Stars
2 Stars
1 Star
0
0
0
0
1
Better off getting this part from junkyard
This part did not do what I wanted it to, after installing it, hood was stuck closed, I replaced this part with one from a junkyard car. If you compare this part to a stock Toyota latch, the latch that Toyota sold was thicker metal, in my opinion better springs. This part fits the car, maybe I got a bad one.
September 4, 2017
Purchased
1 year ago
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

Year Make Model Description
1993-1997Toyota Corolla Toyota Corolla Hood Latch for Models without Factory Alarm

This part replaces:

  • OE # 5351002020
Part #: 1ABHO00055

Out of Stock

How-to Video:

(04:36 min)