Part Details

  • Regulator Option: without Motor
  • Operation: Power

This Toyota Camry power window regulator is a ready to bolt on, direct replacement part. It's just what you need to get your Toyota in good looking form again!

Specifications:

  • RH (Passenger Side) REAR DOOR
  • Does NOT include power window motors
  • Replaces dealer part number: 69830-32090, 6983032090
  • Direct bolt on replacement
  • Built to strict quality control standards
  • Fits 4 Door Sedan models only

Please Note:

This window regulator is designed to work with factory style motors only.  Due to variations in aftermarket designs, replacement motors may not have the correct gear style.

Please Note:

This window regulator is a high quality aftermarket part that meets or exceeds the performance of the original. It has been subjected to extensive testing and quality control standards. That is why we offer this regulator with our superior warranty!

Rigorously Tested

Build to strict quality standards

Highest Quality Materials

Made from the highest quality materials for extreme durability and premium performance.

Item Condition: New

WARNING:  This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

  1. step : Removing the Door Panel (0:51)
    • Use a screwdriver to pry off the door handle bezel
    • Use a screwdriver to pry off the power window switch
    • Disconnect the power window switch
    • Remove the plug underneath the window switch
    • Remove the Phillips head screw under the plug
    • Remove the Phillips head screw underneath the door grip
    • Press in the center of the door panel pins
    • Remove the door panel pins with a screwdriver or by hand
    • Slide a putty knife in between the door panel and the door
    • Undo the door panel clips
    • Pull off the door panel
  2. step : Removing the Window Regulator (3:06)
    • Carefully pull back the water shield by hand
    • Remove the 10mm bolts from the window
    • Slide the window up
    • Hold the window in place with painter’s tape
    • Remove the regulator rail nuts and the window motor nuts with a 10mm socket
    • Disconnect the window motor wire
    • Remove the cable from the tab using a screwdriver
    • Pull out the regulator
  3. step : Installing the New Regulator (6:48)
    • Attach the cable clip from the old regulator to the new regulator cable
    • Slide the regulator into place
    • Push the window out in order to position the regulator
    • Start the middle regulator rail nut
    • Hold the window motor wire aside
    • Start one of the window motor nuts
    • Connect the window motor wire
    • Connect the remaining nuts
    • Tighten the window motor nuts
    • Push the cable clip into place
    • Tighten the regulator rail nuts
  4. step : Reattaching the Window (9:04)
    • Remove the painter's tape
    • Slowly lower the window into place
    • Reconnect the window bolts
    • Reconnect the power window switch wire
    • Test that the window moves smoothly up and down
  5. step : Reinstalling the Door Panel (9:54)
    • Disconnect the power window switch wire
    • Pull the water shield into place
    • Put the door panel into place
    • Reconnect the power window switch wire
    • Insert the power window switch
    • Insert the door panel pins
    • Insert the door panel screws
    • Reattach the door panel screw plug
    • Reattach the door handle bezel

Tools needed for replacement:

    General Tools

  • Putty Knife

  • Materials, Fluids, and Supplies

  • Painter's Tape

  • Ratchets & Related

  • Socket Extensions
  • Ratchet

  • Screwdrivers & Related

  • Phillips Head Screwdriver
  • Flat Blade Screwdriver

  • Sockets - Metric

  • 10mm Socket

  • Wrenches - Metric

  • 10mm Wrench

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

Year Make Model Description
1992-1996Toyota Camry Toyota Camry 4 Door Sedan Rear Power Window Regulator without Motor Passenger Side

This part replaces:

  • Hollander 135-58221R
  • OE # 6983032090
Part #: 1AWRG01780


Order must be placed by 4pm ET

Get it in: 2 - 4 Business Days

Want it sooner? Choose Next Day Air at Checkout

How-to Video:

(10:47 min)