1991-92 Jeep Crankshaft Position Sensor - 1AECS00030

This replacement Crankshaft Position Sensor is just what you need to get your vehicle in good running condition again!

A bad or malfunctioning crank sensor will often cause a service engine light error code, and or cause a no start condition, or rough running due to inaccurate ignition and fuel timing.

This Crank Sensor features:

• Built to strict quality control standards
• Replaces dealer part numbers: 4638128
• Direct replacement
• 100% factory tested
• 3 terminal Plug
• Fits the following Chrysler engines as listed per application:
  • L4 2.5L (8th Vin Digit P)
  • L6 4.0L (8th Vin Digit S)

Your Engine size can usually be found on a white sticker in the engine compartment near the radiator. If needed, your VIN code is the 8th digit of your vehicles Vehicle Identification number. The VIN can be found on the bottom drivers side corner of the windshield and on your registration. Some refer to the VIN code as the Serial Number.

Our electrical and electronic parts are subject to strict quality control testing. Please ensure proper diagnosis of this item before purchasing as the item cannot be returned once installed or plugged in.

Item Condition: New

Attention California Customers:

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.