Replaces

1997-2000 Chevy Venture Front Wheel Hub & Outer Tie Rod (Set of 4) for Models with ABS

Part Details

  • Front / Rear Location: Front
  • Quantity: Set of 4

  • New

This replacement wheel hub & tie rod kit is just what you need to get your vehicle in good working order again.

Wheel Hub Specifications:

  • Comes as a PAIR
    • Fits both LH (Driver Side) & RH (Passenger Side) FRONT
  • Replaces dealer part numbers: 7470017, 7470105, 7470143, 7470567, 7470568, 12429204
  • Wheel studs already included and installed!
  • Have ABS sensors w/stainless steel sensor wire clips
  • Direct replacements
  • Built to strict quality control standards

Tie Rod Specifications:

  • Comes as a PAIR
    • Fits both LH (Driver Side) & RH (Passenger Side) FRONT
  • Come as shown with greasable joints
  • Direct replacements
  • Built to strict quality control standards

It is very important when installing to tighten the Hub Nut to 118 foot lbs. Failure to use the correct torque specifications will result in premature failure of the hub.

NOTE: For 2001 Models: Replaces hub assemblies with Stainless Steel Sensor Wire Clip. Does not replace hub assemblies with a Plastic Clip.

2 Year Warranty

This item is backed by a 2 Year Warranty. In the event this item should fail during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. Remove the wheel and tire (1:30 in the video)
    • Raise and secure the vehicle.
    • Remove the lug nuts and then the wheel.
  2. Remove Caliper (2:00 in the video)
    • Turn wheels all the way in the opposite direction of the side you are working on.
    • Use your 15mm socket wrench to remove the caliper bolts.
    • Use a wire tie to help prevent stress on the caliper.
  3. Remove brake disk (2:44 in the video)
    • Take care not to touch the disk, and if you do make sure to clean it with rubbing alcohol or mineral spirits.
  4. Remove Hub (2:56 in the video)
    • Remove the 3 bolts securing the hub using your 13mm socket and 3/8 extension and ratchet or breaker bar.
    • You can use penetrating oil to help.
    • Use a 35mm socket to remove the hub nut.
    • Give the axle a slight tap with a hammer to loosen it.
    • Use a rubber mallet to break it free, and work around the flange with the hammer to pull it off.
    • Leave the top 13mm loosely still in to prevent the hub from flying out if you hit it too hard.
    • Remove the hub, using driving tools to help work it out of the steering knuckle.
    • Clean up any corrosion with a wire brush.
  5. Install new hub (8:30 in the video)
    • Use some penetrating oil to prep the knuckle for the new hub.
    • Watch part 2 to install your new 1A Auto hub!

Tools needed for replacement:

    Materials, Fluids, and Supplies

  • Rust Penetrant

  • Ratchets & Related

  • 1/2 Inch Breaker Bar
  • Ratchet
  • Socket Extensions
  • Torque Wrench

  • Screwdrivers & Related

  • Phillips Head Screwdriver

  • Sockets - Metric

  • 13mm Socket
  • 19mm Socket
  • 32mm Socket
  • 35mm Socket

  • Specialty Tools

  • Floor Jack
  • Hammer
  • Jack Stands
  • Rubber Mallet

How-to Video:

(09:37 min)

Tools List:

    Materials, Fluids, and Supplies

  • Rust Penetrant

  • Ratchets & Related

  • 1/2 Inch Breaker Bar
  • Ratchet
  • Socket Extensions
  • Torque Wrench

  • Screwdrivers & Related

  • Phillips Head Screwdriver

  • Sockets - Metric

  • 13mm Socket
  • 19mm Socket
  • 32mm Socket
  • 35mm Socket

  • Specialty Tools

  • Floor Jack
  • Hammer
  • Jack Stands
  • Rubber Mallet




Vehicle Fit

  • 1997-2000 Chevy Venture Front Wheel Hub & Outer Tie Rod (Set of 4) for Models with ABS
  • 2001-2005 Chevy Venture Front Wheel Hub & Outer Tie Rod (Set of 4) for Models & with ABS (excluding All Wheel Drive Models)
  • 1997-2000 Olds Silhouette Front Wheel Hub & Outer Tie Rod (Set of 4) for Models with ABS
  • 2001-2004 Olds Silhouette Front Wheel Hub & Outer Tie Rod (Set of 4) for Models & with ABS (excluding All Wheel Drive Models)
  • 1997-2003 Pontiac Grand Prix Front Wheel Hub & Outer Tie Rod (Set of 4) for Models with ABS
  • 1999-2000 Pontiac Montana Front Wheel Hub & Outer Tie Rod (Set of 4) for Models with ABS
  • 2001-2005 Pontiac Montana Front Wheel Hub & Outer Tie Rod (Set of 4) for Models & with ABS (excluding All Wheel Drive Models)
  • 1997-1998 Pontiac Trans Sport Front Wheel Hub & Outer Tie Rod (Set of 4) for Models with ABS
$99.95
Part #: 1AHTF00005

- Ships Same Day for orders placed by 5 P.M. ET

Free GROUND SHIPPING

Check Shipping Rates

We're here to help

Customer Feedback

Customer Feedback
"Thanks for the fast reliable service. Great price, and the headlights were as good as oem or better!!! Keep up the good work..."
- Dwuan M.
Read More
Free Shipping!
OR
CALL
TOLL
FREE

888-844-3393

hablamos Español:866-401-3393
SHIPS SAME DAY
For Orders Placed By 5pm Est