Replaces

2004-2008 Pontiac Grand Prix Front Wheel Bearing & Hub Assembly (Without ABS Brakes) (Timken)

Part Details

  • Front / Rear Location: Front
  • Brands: Timken

This part replaces:

  • Timken HA590085
  • OE # 88964096
  • HOLLANDER 538-01634 538-01722

  • New

TIMKEN WHEEL BEARING & HUB ASSEMBLY: HA590085

This replacement hub & bearing assembly is just what you need to get your vehicle in good working order again.

Specifications:

  • Brand New Timken Wheel Bearing & Hub Assembly
  • Fits LH (Driver Side) or RH (Passenger Side) FRONT
  • Replaces dealer part numbers: 88964096
  • Direct replacement
  • Built to strict quality control standards
  • New wheel studs installed
  • Correct for models without ABS

Note: This part is an authentic Timken brand product that is supplied and packaged by Timken.   In some cases, Timken will source parts from other high quality suppliers such as SKF and Koyo. These parts are subjected to the very same testing and quality standards as all Timken products.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. Removing the Door Panel (0:37)
    • Pry up the door pull trim piece with a flat blade screwdriver
    • Remove the two 7mm bolts from the door pill
    • Pry out the door panel clips with a putty knife
    • Pull the door handle out of the door panel
    • Lift the door panel up and off
    • Push the window switch out of the door panel from behind
    • Disconnect the window switch wiring harness
    • Peel off the water shield, using a razor blade if necessary
  2. Removing the Window Regulator (1:58)
    • Lower the window to access the window clamp nuts
    • Disconnect the window motor wiring harness
    • Loosen the two 10mm nuts from the window clamp
    • Pull the window out of its clamp
    • Unclip the regulator cables from the door
    • Remove the lower two 10mm bolts from the regulator
    • Loosen the top ten mm bolt from the regulator
    • Pull the window regulator out of the door
  3. Installing the New Window Regulator (3:21)
    • Remove the top 10mm bolt from the old regulator
    • Insert the 10mm bolt into the new regulator
    • Hang the new regulator in place by the bolt
    • Insert the lower two 10mm bolts into the regulator
    • Tighten all three 10mm bolts
    • Clip the regulator cables into the door
    • Loosen the 10mm window clamp nuts
    • Connect the window motor wiring harness
    • Lower the window onto its clamps
    • Tighten the 10mm window clamp nuts
    • Put the ignition in accessory mode
    • Connect the window switch wiring harness
    • Test the window with the switch
    • Disconnect the window switch wiring harness
    • Turn the ignition off
  4. Reinstalling the Door Panel (5:02)
    • Put the water shield into place
    • Push the door panel shield onto the door panel
    • Thread the wiring harness through the window switch cavity
    • Lift the door panel into place
    • Push in the door panel clips
    • Connect the window switch wiring harness
    • Push the window switch into the door
    • Insert the two 7mm bolts into the door pull
    • Push in the door pull trim piece

Tools needed for replacement:

    General Tools

  • Putty Knife
  • Razor Blade / Gasket Scraper

  • Ratchets & Related

  • Ratchet

  • Screwdrivers & Related

  • Flat Blade Screwdriver

  • Sockets - Metric

  • 10mm Socket
  • 7mm Socket

How-to Video:

(06:28 min)

Tools List:

    General Tools

  • Putty Knife
  • Razor Blade / Gasket Scraper

  • Ratchets & Related

  • Ratchet

  • Screwdrivers & Related

  • Flat Blade Screwdriver

  • Sockets - Metric

  • 10mm Socket
  • 7mm Socket



This part replaces:

  • Timken HA590085
  • OE # 88964096
  • HOLLANDER 538-01634 538-01722

Vehicle Fit

  • 2005-2008 Buick Allure Front Wheel Bearing & Hub Assembly (Without ABS Brakes) (Timken)
  • 2003-2005 Buick Century Front Wheel Bearing & Hub Assembly (Without ABS Brakes) (Timken)
  • 2005-2008 Buick LaCrosse Front Wheel Bearing & Hub Assembly (Without ABS Brakes) (Timken)
  • 2002-2004 Buick Regal Front Wheel Bearing & Hub Assembly (Without ABS Brakes) (Timken)
  • 2003-2007 Buick Rendezvous Front Wheel Bearing & Hub Assembly (Without ABS Brakes) (Timken)
  • 2000-2008 Chevy Impala Front Wheel Bearing & Hub Assembly (Without ABS Brakes) (Timken)
  • 2000-2007 Chevy Monte Carlo Front Wheel Bearing & Hub Assembly (Without ABS Brakes) (Timken)
  • 2003-2005 Chevy Venture Front Wheel Bearing & Hub Assembly (Without ABS Brakes) (Timken)
  • 2003-2005 Pontiac Aztek Front Wheel Bearing & Hub Assembly (Without ABS Brakes) (Timken)
  • 2004-2008 Pontiac Grand Prix Front Wheel Bearing & Hub Assembly (Without ABS Brakes) (Timken)
  • 2003-2005 Pontiac Montana Front Wheel Bearing & Hub Assembly (Without ABS Brakes) (Timken)
  • 2005 Pontiac Montana SV6 Front Wheel Bearing & Hub Assembly (Without ABS Brakes) (Timken)
$134.95
Save 39%
List: $222.00 Save: $87.05
Only 4 left in stock
Part #: TKSHF00129

Ships Same Day for orders placed by 5 P.M. ET

Free GROUND SHIPPING

Check Shipping Rates
Timken
Brand #: HA590085

We're here to help

1A Auto Parts

Customer Feedback

Customer Feedback
"Thanks for the fast reliable service. Great price, and the headlights were as good as oem or better!!! Keep up the good work..."
- Dwuan M.
Read More
Free Shipping!
OR
CALL
TOLL
FREE

888-844-3393

hablamos Español:866-401-3393
SHIPS SAME DAY
For Orders Placed By 5pm Est