Replaces

2000-2001 VW Golf DOWNSTREAM O2 Oxygen Sensor for L4 2.0L ( Engine ID AEG)

This part replaces:

  • OE # 06A906262F
  • STANDARD MOTOR PRODUCTS SG901

  • New

This O2 Sensor is just what you need to get your vehicle running great again!

Specifications:

  • Direct Fit
    • Correct Connector No cutting or splicing
    • Correct wire length (19.4 Inches)
  • Downstream Sensor
  • 4 wire configuration
  • Replaces dealer part numbers: 058906265C, 058 906 265 C, 06A906262AH, 06A 906 262 AH, 06A906262AJ, 06A 906 262 AJ, 06A906262BG, 06A 906 262 BG, 06A906262BM, 06A 906 262 BM
  • Built and tested to strict quality control standards

Note: For clarification purposes:

  • Upstream location is between the catalytic converter and the engine
  • Downstream location is between the catalytic converter and the tailpipe

If you have a bad O2 sensor causing your vehicle to run poorly or fail an emission test then this is the part for you.

Note:  You may be required to reset the vehicle’s computer after installation of this part.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. Removing the Downstream Oxygen (O2) Sensor (0:41 in the video)
    • Remove the two 10mm nuts from the O2 sensor wiring harness cover
    • Pull off the wiring harness cover
    • Pull the wiring harnesses out of their brackets
    • Disconnect the downstream sensor wiring harness
    • Unclip the wiring harness
    • Loosen the O2 sensor with a 7/8 inch wrench
    • Pull off the O2 sensor
  2. Installing the New Downstream O2 Sensor (1:36 in the video)
    • Put the new O2 sensor into place
    • Tighten the new O2 sensor with a 7/8 inch wrench
    • Clip the wiring harness into place
    • Connect the wiring harness
    • Push the harnesses into their brackets
    • Hang the wiring harness cover on its studs
    • Fasten the two 10mm nuts onto the wiring harness cover

Tools needed for replacement:

    Ratchets & Related

  • Ratchet

  • Screwdrivers & Related

  • Flat Blade Screwdriver

  • Sockets - Metric

  • 10mm Socket

  • Specialty Tools

  • Floor Jack
  • Jack Stands

  • Wrenches - SAE

  • 7/8 Inch Wrench

How-to Video:

(03:02 min)

Tools List:

    Ratchets & Related

  • Ratchet

  • Screwdrivers & Related

  • Flat Blade Screwdriver

  • Sockets - Metric

  • 10mm Socket

  • Specialty Tools

  • Floor Jack
  • Jack Stands

  • Wrenches - SAE

  • 7/8 Inch Wrench



This part replaces:

  • OE # 06A906262F
  • STANDARD MOTOR PRODUCTS SG901

Vehicle Fit

  • 1999 VW Beetle DOWNSTREAM O2 Oxygen Sensor for L4 2.0L ( From VIN # 1CX460000)
  • 2000-2001 VW Beetle DOWNSTREAM O2 Oxygen Sensor for L4 2.0L ( Engine ID AEG)
  • 1999 VW Golf DOWNSTREAM O2 Oxygen Sensor for L4 2.0L ( Engine ID AEG) ( From VIN# 1JX697003)
  • 2000-2001 VW Golf DOWNSTREAM O2 Oxygen Sensor for L4 2.0L ( Engine ID AEG)
  • 1999 VW Jetta DOWNSTREAM O2 Oxygen Sensor for L4 2.0L ( Engine ID AEG) ( From VIN# 9MX085424)
  • 2000-2001 VW Jetta DOWNSTREAM O2 Oxygen Sensor for L4 2.0L ( Engine ID AEG)
$99.95
Save 47%
List: $188.00 Save: $88.05
Part #: 1AEOS00106

- Ships Same Day for orders placed by 5 P.M. ET

Free GROUND SHIPPING

Check Shipping Rates

We're here to help

Customer Feedback

Customer Feedback
"Thanks for the fast reliable service. Great price, and the headlights were as good as oem or better!!! Keep up the good work..."
- Dwuan M.
Read More
Free Shipping!
OR
CALL
TOLL
FREE

888-844-3393

hablamos Español:866-401-3393
SHIPS SAME DAY
For Orders Placed By 5pm Est