Replaces

1998-1998 Chevy S10 Pickup Turn Signal, Wiper, and Cruise Control Switch Lever with Cruise Control (w/ RPO code ZN4)

This part replaces:

  • STANDARD MOTOR PRODUCTS DS-933
  • HOLLANDER 629-00309
  • OE # 26083635

  • New

This combination cruise control, wiper, high beam and turn signal switch lever is a new, aftermarket replacement part. It is designed to REPLACE original units that are prone to failure. It's just what you need to get your vehicle in good working order again!

Specifications:

  • Replaces dealer part number(s): 26083635 , 26100837, 26096832, 8260822450, 8261008370
  • Direct replacement
  • Design improved for more durability
  • Detailed graphics
  • Built to strict quality control standards
  • Correct for vehicles WITH CRUISE CONTROL

This combination lever is designed to replace your original with no modifications necessary.

Lifetime Warranty

Effective June 23, 2014: This item is backed by a manufacturer's Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. Disconnect the battery
    • Use your 8 mm wrench to disconnect the negative battery terminal.
  2. remove the panel under the steering column
    • Use your 7 mm socket and ratchet to remove the bolts.
    • Remove the four 10 mm nuts securing the secondary panel under the steering column.
  3. Remove the cruise control release
    • Unclip the cruise control release and disconnect it.
    • Set aside somewhere safe.
  4. Remove the turn signal switch
    • Carefully cut the wire ties and remove protective fabric covering the wires.
    • Follow the wire ties down to the junction block and unplug them.
    • Use your screwdriver to pry off your tilt lever.
    • Remove the two T25 screws securing the steering column cover
    • Remove the E5 Star bolt underneath by the lock cylinder
    • Reinstall the tilt lever and lower the column and remove the top cover.
    • Unplug the small green plug connecting the turn signal switch.
    • Unscrew the T25 screws securing the switch.
    • Poke the wire out of the junction block with a screwdriver.
  5. Install the new turn signal switch
    • Plug in the connector to the junction block.
    • Secure the switch with your T25 Driver
    • Plug in the green connector for the cruise control cancel.
    • Connect the junction block.
    • Reconnect your negative battery terminal and test that the wiring is all working properly.
    • Tidy everything up with wire ties and the shielding fabric.
    • Put the steering column trim panels on, screwing in the E5 screw and a T25 Torx screws.
    • Put the two panels back on with your 7 and 10 mm sockets and ratchet.

How-to Video:

(12:11 min)

Tools List:

    Ratchets & Related

  • Ratchet
  • Socket Extensions

  • Sockets - Metric

  • 10mm Socket
  • 7mm Socket

  • Torx Drivers & Sockets

  • E5 Inverted Torx Socket
  • T25 Torx Driver

  • Wrenches - Metric

  • 8mm Wrench



This part replaces:

  • STANDARD MOTOR PRODUCTS DS-933
  • HOLLANDER 629-00309
  • OE # 26083635

Vehicle Fit

  • 1999-2005 Chevy Blazer S10 Turn Signal, Wiper, and Cruise Control Switch Lever with Cruise Control
  • 1998 Chevy S10 Pickup Turn Signal, Wiper, and Cruise Control Switch Lever with Cruise Control (w/ RPO code ZN4)
  • 1999-2004 Chevy S10 Pickup Turn Signal, Wiper, and Cruise Control Switch Lever with Cruise Control
  • 1998 GMC Envoy Turn Signal, Wiper, and Cruise Control Switch Lever with Cruise Control (w/ switch ID 26083635)
  • 1999-2000 GMC Envoy Turn Signal, Wiper, and Cruise Control Switch Lever with Cruise Control
  • 1999-2001 GMC Jimmy S-15 Turn Signal, Wiper, and Cruise Control Switch Lever with Cruise Control
  • 1998 GMC S-15 Sonoma Turn Signal, Wiper, and Cruise Control Switch Lever with Cruise Control (w/ RPO code ZN4)
  • 1999-2004 GMC S-15 Sonoma Turn Signal, Wiper, and Cruise Control Switch Lever with Cruise Control
  • 1999-2000 Isuzu Hombre Turn Signal, Wiper, and Cruise Control Switch Lever with Cruise Control
  • 1998 Olds Bravada Turn Signal, Wiper, and Cruise Control Switch Lever with Cruise Control (w/ switch ID 26083635)
  • 1999-2001 Olds Bravada Turn Signal, Wiper, and Cruise Control Switch Lever with Cruise Control
$80.45
Save 62%
List: $209.65 Save: $129.20
Part #: 1AZCC00033

- Ships Same Day for orders placed by 5 P.M. ET

Free GROUND SHIPPING

Check Shipping Rates

We're here to help

Customer Feedback

Customer Feedback
"Thanks for the fast reliable service. Great price, and the headlights were as good as oem or better!!! Keep up the good work..."
- Dwuan M.
Read More
Free Shipping!
OR
CALL
TOLL
FREE

888-844-3393

hablamos Español:866-401-3393
SHIPS SAME DAY
For Orders Placed By 5pm Est