Replaces

2001-2007 Toyota Sequoia Window Regulator Power Passenger Side Front with Motor

Part Details

  • Operation: Power
  • Location: Passenger Side
  • Location: Front

This part replaces:

  • OE # 69801-0C020, 85710-34030
  • HOLLANDER 125-58887R, 617-58815
  • PARTSLINK TO1351144

  • New

This replacement power window regulator with motor is just what you need to get your vehicle in good shape again!

Specifications:

  • RH (Passenger Side) FRONT DOOR
  • Replaces dealer part numbers: 69801-0C020, 85710-34030, 698010C020, 8571034030
  • Power operation
  • Direct replacement
  • 2-pin Motor
    • Not correct for models with 6-pin connector
  • Includes power window motor already assembled to regulator
  • Built to strict quality control standards
  • Only fits Double Cab on Tundra Models

This power window regulator with motor makes a great replacement and has good cost savings over a dealer unit.

 

Please Note: This High Quality power window regulator is a new aftermarket replacement part that is built to strict quality control standards. It is far superior to the lower quality window regulators which have begun to appear on the internet. Although this window regulator is produced overseas, it was designed in the U.S. and the tooling is owned by a large U.S. manufacturer. That is why we guarantee this high quality window regulator with a superior warranty! If price is your main concern, we do offer the lower price overseas designed and built window regulator in our other listings.

Installation

  • This repair is easier than you may think. You'll find our installation videos helpful. In our experience removing and replacing the door panel is the most involved step in the repair. On most vehicles this only requires removing a few screws and push in clips.
  • You'll get a great feeling of accomplishment after you complete this repair knowing you saved money, and you didn't have to give up your car for a day at the repair shop. Your passengers and other drivers will be amazed.

Fit guaranteed

  • 1A Auto will refund you with no hassle, if this Window regulator does not fit the application stated.
    • You can use your existing hardware and wiring harnesses. This Regulator will install just as your original does. Save time and money.

Quality

  • Be confident this part will work right. Every regulator is tested after assembly to make sure all mechanisms are working correctly.
  • It is important that your new regulator works for a long period of time. The design of this regulator is tested to withstand 10,000 cycles. That is enough to raise and lower your window 3 times per day for 9 years.
  • Nothing is more frustrating than taking your car apart and finding the part you purchased does not fit. You want the part to fit. This design is test fit on an actual door. When you install it, you will have no issues.

Value

  • Windows that don't work can be frustrating. They can also hurt your vehicles value. An inoperable window could mean $200-$500 discounted off a dealer trade value or asking price.
  • Some shops and dealers charge more for parts and repairs when they think you don't know what is involved. Now you can get the value you deserve. Knowing what this repair entails can be the difference between the value of doing it yourself, or the pain of a costly repair bill.

 

Lifetime Warranty

Effective June 23, 2014: This item is backed by a manufacturer's Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. Disconnecting the Battery
    • Disconnect the negative battery cable
  2. Removing the Door Panel
    • Pry off the mirror base trim with a flat blade screwdriver
    • Pry off the window switch panel with a flat blade screwdriver
    • Disconnect the window switch wiring harnesses
    • Pry off the screw cover beneath the door pull with a flat blade screwdriver
    • Pry off the courtesy light with a flat blade screwdriver
    • Disconnect the courtesy light wiring harness
    • Pry off the screw cover inside the door panel with a flat blade screwdriver
    • Pry off the screw cover at the front top corner of the door panel with a flat blade screwdriver
    • Remove the Phillips head screw at the front top corner of the door panel
    • Remove the Phillips screw inside the door handle
    • Remove the Phillips screw under the door pull
    • Pry off the door handle bezel with a flat blade screwdriver
    • Remove the two plastic clips from the back edge of the door panel
    • Pry off the door panel with a door panel clip tool or a putty knife
    • Pull the door panel up and off
    • Remove any clips still in the door with needle nose pliers
    • Push the clips into the door panel
    • Carefully peel back the water shield
    • Remove three bolts from the speaker
    • Remove the speaker
  3. Removing the Window Regulator
    • Disconnect the window motor wiring harness
    • Remove the two 10mm bolts from the window track
    • Remove the four 10mm bolts from the window regulator
    • Remove the two 10mm bolts from the window clamps
    • Separate the window from the regulator
    • Raise the window by hand
    • Hold the window in place with painter's tape
    • Pull the regulator out of the door
  4. Separating the Window Motor
    • Pry off the balance spring with a flat blade screwdriver
    • Remove the three T25 Torx screws from the motor
    • Separate the motor from the regulator
  5. Installing the New Window Motor
    • Put the motor into place
    • Start the three T25 Torx screws
    • Tighten the screws
    • Pull the spring into place with a flat blade screwdriver
  6. Reinstalling the Regulator
    • Thread the top bolt onto the regulator
    • Slide the regulator into the door.
    • Hang the regulator by its bolt
    • Start the other five 10mm bolts into the regulator
    • Tighten the six 10mm bols
    • Reconnect the window motor lead
    • Reconnect the negative battery cable
    • Reconnect the window switch wiring harness
    • Turn on the vehicle
    • Lower the regulator with the window switch
    • Remove the painter's tape from the window
    • Slide the window down onto the regulator
    • Insert the two 10mm bolts into the window clamps
    • Test that the window works with the window switch
    • Turn off the vehicle
    • Disconnect the window switch harness
    • Disconnect the negative battery cable
  7. Reinstalling the Door Panel
    • Put the water shield back into place
    • Put the speaker into place
    • Insert the three bolts into the speaker
    • Lift the door panel into place
    • Pull the wiring harnesses through their cavities
    • Push on the mirror trim piece
    • Push on the door panel bezel
    • Connect the window switch wiring harness
    • Push in the window switch panel
    • Connect the courtesy light wiring harness
    • Insert the Phillips screw below the door pull
    • Insert the Phillips screw inside the door handle
    • Insert the Phillips screw at the top front corner of the door panel
    • Push in the screw cover at the top front corner of the door panel
    • Push in the screw cover inside the door handle
    • Push in the screw cover beneath the door pull
    • Push in the two plastic clips at the rear edge of the door panel
  8. Reconnecting the Battery
    • Reconnect the negative battery cable

How-to Video:

(14:17 min)

Tools List:

    Materials, Fluids, and Supplies

  • Painter's Tape

  • Pliers, Cutters & misc Wrenches

  • Needle nose pliers

  • Ratchets & Related

  • Ratchet

  • Screwdrivers & Related

  • Flat Blade Screwdriver
  • Phillips Head Screwdriver

  • Sockets - Metric

  • 10mm Socket

  • Specialty Tools

  • Door Panel Removal Tool
  • Putty Knife



This part replaces:

  • OE # 69801-0C020, 85710-34030
  • HOLLANDER 125-58887R, 617-58815
  • PARTSLINK TO1351144

Vehicle Fit

  • 2001-2007 Toyota Sequoia Window Regulator Power Passenger Side Front with Motor
  • 2004-2006 Toyota Tundra Double Cab Front Power Window Regulator with Motor Passenger Side
$56.45
Save 88%
List: $479.69 Save: $423.24
Part #: 1AWRG01049

- Ships Same Day for orders placed by 5 P.M. ET

Free GROUND SHIPPING

Check Shipping Rates

We're here to help

Customer Feedback

Customer Feedback
"Thanks for the fast reliable service. Great price, and the headlights were as good as oem or better!!! Keep up the good work..."
- Dwuan M.
Read More
Free Shipping!
OR
CALL
TOLL
FREE

888-844-3393

hablamos Español:866-401-3393
SHIPS SAME DAY
For Orders Placed By 5pm Est