Replaces

1997-2002 Ford Expedition 2 Wheel Drive 9 Piece Set Steering & Suspension Kit with (2) Front Upper Control Arms with Ball Joints (2) Front Lower Ball Joints (2) Front Inner Tie Rods (2) Front Outer Tie Rods & (1) Pitman Arm

Part Details

  • Kit Includes: (2) Front Lower Ball Joints
  • Quantity: 9 Piece Set
  • Kit Includes: (2) Front Upper Control Arms with Ball Joints
  • Kit Includes: (2) Front Outer Tie Rods
  • Kit Includes: (2) Front Inner Tie Rods
  • Kit Includes: (1) Pitman Arm

  • New

Specifications:

  • Brand New Steering & Suspension Kit
  • Comes as a 9 Piece Kit
    • Fits LH (Driver Side) & RH (Passenger Side)
  • Direct replacement
  • Built to strict quality control standards

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. Step 1: Removing the Wheel (0:55)
    • Remove the center cap.
    • Loosen the lug nuts.
    • Raise the vehicle.
    • Remove the lug nuts.
    • Remove the wheel.
  2. Step 2: Removing the Front Upper Control Arm (1:10)
    • Jack up the lower control arm to support the suspension.
    • Mark the upper bolts on the control arm with a marker to remember their alignment. Draw a line on the bolt and on to the bracket.
    • Remove the cotter pin from the balljoint.
    • Spray the ball join and upper bolts with penetrating oil.
    • Us a 21mm socket on the balljoint bolt. Hammer it on.
    • Use a breaker bar and pipe for added leverage to loosen the 21mm bolt. Don’t full remove the bolt.
    • Loosen the other two 21mm bolts using a socket and breaker bar.
    • Remove the nut from the balljoint and use a balljoint puller tool to separate the control arm and steering knuckle.
    • Use a 19mm to tighten the balljoint removal tool until it pops.
    • Remove the upper nuts and bolts.
    • Pull the control arm free.
  3. Step 3: Installing the New Control Arm (7:18)
    • Use a wire brush where the control arm goes.
    • Put the new control arm in place.
    • Push it down onto the balljoint and start the bolts.
    • Reinsert the upper bolts. Line the marks up.
    • Torque Ball joint nut to 67ft/lbs.
    • Insert new cotter pin and use pliers to bend the end.
    • Put a grease fitting on and pump grease into the ball joint.
    • Raise the vehicle so all the weight is on the suspension.
    • Torque the upper bolts to 100ft/lbs.
  4. Step 4: Reinstalling the Wheel (10:57)
    • Put the wheel in place.
    • Replace the lug nuts.
    • Lower the vehicle.
    • Tighten the lug nuts to 100ft/lbs in a star pattern.
    • Replace the center cap.

Tools needed for replacement:

    General Tools

  • Jack Stands
  • Hammer

  • Materials, Fluids, and Supplies

  • Rust Penetrant
  • Marker / Writing Utensil

  • Pliers, Cutters & misc Wrenches

  • Needle nose pliers

  • Ratchets & Related

  • Ratchet
  • 1/2 Inch Breaker Bar
  • A Piece of Pipe (for leverage)

  • Sockets - Metric

  • 19mm Socket
  • 21mm Socket

  • Specialty Tools

  • Ball Joint Press

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

How-to Video:

(11:43 min)

Tools List:

    General Tools

  • Jack Stands
  • Hammer

  • Materials, Fluids, and Supplies

  • Rust Penetrant
  • Marker / Writing Utensil

  • Pliers, Cutters & misc Wrenches

  • Needle nose pliers

  • Ratchets & Related

  • Ratchet
  • 1/2 Inch Breaker Bar
  • A Piece of Pipe (for leverage)

  • Sockets - Metric

  • 19mm Socket
  • 21mm Socket

  • Specialty Tools

  • Ball Joint Press




Vehicle Fit

  • 1997-2002 Ford Expedition 2 Wheel Drive 9 Piece Set Steering & Suspension Kit with (2) Front Upper Control Arms with Ball Joints (2) Front Lower Ball Joints (2) Front Inner Tie Rods (2) Front Outer Tie Rods & (1) Pitman Arm
  • 2004 Ford F150 Heritage Truck 2 Wheel Drive 9 Piece Set Steering & Suspension Kit with (2) Front Upper Control Arms with Ball Joints (2) Front Lower Ball Joints (2) Front Inner Tie Rods (2) Front Outer Tie Rods & (1) Pitman Arm
  • 1997-2003 Ford F150 Truck 2 Wheel Drive 9 Piece Set Steering & Suspension Kit with (2) Front Upper Control Arms with Ball Joints (2) Front Lower Ball Joints (2) Front Inner Tie Rods (2) Front Outer Tie Rods & (1) Pitman Arm
  • 1997-1999 Ford F250 Light Duty Truck 2 Wheel Drive 9 Piece Set Steering & Suspension Kit with (2) Front Upper Control Arms with Ball Joints (2) Front Lower Ball Joints (2) Front Inner Tie Rods (2) Front Outer Tie Rods & (1) Pitman Arm
  • 1998-2002 Lincoln Navigator 2 Wheel Drive 9 Piece Set Steering & Suspension Kit with (2) Front Upper Control Arms with Ball Joints (2) Front Lower Ball Joints (2) Front Inner Tie Rods (2) Front Outer Tie Rods & (1) Pitman Arm
$ 144.95
Save 32%
List: $212.15 Save: $67.20
Part #: 1ASFK00462

Ships Same Day for orders placed by 5 P.M. ET

Free GROUND SHIPPING

Check Shipping Rates

We're here to help

1A Auto Parts

Customer Feedback

Customer Feedback
"Thanks for the fast reliable service. Great price, and the headlights were as good as oem or better!!! Keep up the good work..."
- Dwuan M.
Read More
Free Shipping!
OR
CALL
TOLL
FREE

888-844-3393

hablamos Español:866-401-3393
SHIPS SAME DAY M-F
For Orders Placed By 5pm Est