Replaces

2002-2004 Infiniti I35 Power Window Motor Rear Passenger Side (Remanufactured)

This part replaces:

  • OE # 80730-EA005

  • Remanufactured

This Nissan remanufactured power window motor is just what you need to get your vehicle in good shape again! If your window regulator is good, but the motor is burned out, then this is the part for you.

Specifications:

  • RH (Passenger Side) FRONT or REAR DOOR as listed per application
  • Replaces dealer part numbers: 80730-EA005, 80730-EA005, 8073089906, 8073089906, 8073089912, 8073089912, 80730-89906, 80730-89906, 80730-89912, 80730-89912, 827303Z005, 827303Z005, 82730-3Z005, 82730-3Z005, 827308J000, 827308J000, 82730-8J000, 82730-8J000
  • Direct replacement
  • Each remanufactured power window motor has these features and benefits:
    • Each unit is 100% computer tested at 3 points in the manufacturing process. - Guaranteed performance every time.
    • Every motor is assembled with the precise amount of lubricant. - Ensures quiet operation and long life.
    • Motor magnets are 100% recharged. - OE performance and reliability.
    • New high quality gaskets are used in every window lift unit. - Prevents water from entering the unit eliminating failure modes related to water penetration.
  • Rebuilt to strict quality control standards
  • No core charge

This window motor makes a great replacement and has substantial cost savings over a dealer unit.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. Removing the Door Panel (0:49 in the video)
    • Pry off the door pull panel by hand
    • Pry off the window switch panel by hand
    • Disconnect the window switch wiring harness
    • Remove the 10mm Phillips head bolts behind the door pull
    • Pry off the clip at the front of the door panel
    • Remove the Phillips screw at the bottom of the door panel
    • Pry the door handle bezel off with a flat blade screwdriver
    • Pull the door panel off by hand
    • Carefully remove the water shield with a putty knife
  2. Removing the Window Regulator (3:48 in the video)
    • Move the window by hand until you can access the window bolts
    • Remove the 10mm window bolts
    • Lift the window by hand
    • Turn the window and pull it out
    • Disconnect the window motor wiring harness
    • Remove the three 10mm bolts from the window motor
    • Remove the four 10mm bolts from the window regulator rail
    • Pull the window regulator and motor out of the door
  3. Disconnecting the Window Motor (6:06 in the video)
    • Remove the three screws from the window motor with a Phillips head ratchet bit
    • Remove the motor from the regulator
  4. Connecting the New Motor to the Regulator (6:59 in the video)
    • Line up the motor with the regulator
    • Start the three screws by hand
    • Use the Phillips head ratchet bit to tighten the three screws
  5. Reinstalling the Regulator (7:37 in the video)
    • Start the top left regulator rail bolt by hand
    • Slide the regulator and motor into the door
    • Hang the regulator in place by the bolt
    • Hang the motor in place with its two teeth
    • Thread all the 10mm bolts by hand
    • Tighten all the bolts with the 10mm socket
    • Connect the window motor wiring harness
    • Slide your window into the door, starting with the front corner
    • Push the window on to its track
    • Insert the bolts that connect the window to the regulator
    • Connect the window switch wiring harness
    • Test that the window works
    • Disconnect the window switch wiring harness
  6. Reinstalling the Door Panel (10:06 in the video)
    • Carefully put the water shield back on
    • Thread the window switch wiring harness through its cavity
    • Put the door panel on
    • Push the door panel clips in
    • Insert the 10mm Phillips bolts behind the door pull
    • Insert the plastic clip at the front of the door panel
    • Insert the Phillips head screw at the bottom of the door panel
    • Push on the door handle bezel by hand
    • Connect the power window switch wiring harness
    • Push the power window switch into the door starting at the front
    • Push the door pull panel into place

Tools needed for replacement:

    Ratchets & Related

  • 3/8 Inch Drive Ratchet
  • Ratchet
  • Socket Extensions

  • Screwdrivers & Related

  • Flat Blade Screwdriver
  • Phillips Head Screwdriver

  • Sockets - Metric

  • 10mm Socket

  • Specialty Tools

  • Putty Knife

  • Wrenches - Metric

  • 10mm Wrench

How-to Video:

(12:59 min)

Tools List:

    Ratchets & Related

  • 3/8 Inch Drive Ratchet
  • Ratchet
  • Socket Extensions

  • Screwdrivers & Related

  • Flat Blade Screwdriver
  • Phillips Head Screwdriver

  • Sockets - Metric

  • 10mm Socket

  • Specialty Tools

  • Putty Knife

  • Wrenches - Metric

  • 10mm Wrench



This part replaces:

  • OE # 80730-EA005

Vehicle Fit

  • 2000-2001 Infiniti I30 Power Window Motor Rear Passenger Side (Remanufactured)
  • 2002-2004 Infiniti I35 Power Window Motor Rear Passenger Side (Remanufactured)
  • 2002-2006 Nissan Altima Power Window Motor Rear Passenger Side (Remanufactured)
  • 2005-2012 Nissan Frontier Power Window Motor Front Passenger Side (Remanufactured)
  • 2000-2001 Nissan Maxima Power Window Motor Front Passenger Side (Remanufactured)
  • 2000-2003 Nissan Maxima Power Window Motor Rear Passenger Side (Remanufactured)
  • 2003-2007 Nissan Murano Power Window Motor Rear Passenger Side (Remanufactured)
  • 2005-2006 Nissan Pathfinder Front Passenger Side Power Window Motor (Remanufactured) (excluding Express Up & Down)
  • 2001 Nissan Sentra Power Window Motor Front Passenger Side (Built After 5/01/01 Production Date) (Remanufactured)
  • 2002-2006 Nissan Sentra Power Window Motor Front Passenger Side (Remanufactured)
  • 2007-2011 Nissan Versa Power Window Motor Front Passenger Side (Remanufactured)
  • 2012 Nissan Versa Hatchback Front Power Window Motor Passenger Side
  • 2005-2006 Nissan X-Trail Power Window Motor Rear Passenger Side (Remanufactured)
  • 2005-2006 Nissan X-Trail Power Window Motor Front Passenger Side (Remanufactured)
  • 2005-2012 Nissan Xterra Power Window Motor Front Passenger Side (Remanufactured)
$104.95
Save 60%
List: $260.00 Save: $155.05
Only 3 left in stock
Part #: 1AWPM00128

- Ships Same Day for orders placed by 5 P.M. ET

Free GROUND SHIPPING

Check Shipping Rates

We're here to help

Customer Feedback

Customer Feedback
"Thanks for the fast reliable service. Great price, and the headlights were as good as oem or better!!! Keep up the good work..."
- Dwuan M.
Read More
Free Shipping!
OR
CALL
TOLL
FREE

888-844-3393

hablamos Español:866-401-3393
SHIPS SAME DAY
For Orders Placed By 5pm Est