Replaces

1994-1996 Chrysler New Yorker 9 Tooth Window Motor Front or Rear Driver Side

This part replaces:

  • HOLLANDER 617-00306L, 617-00323L
  • OE # 4624625
  • DORMAN 742-310

  • New

This replacement power window motor is just what you need to get your vehicle in good shape again! If your window regulator is good, but the motor is burned out, then this is the part for you.

Specifications:

  • Fits LH (Driver Side)
  • Replaces dealer part number: 4624625
  • Direct replacement
  • New not remanufactured
  • 9 tooth gear
  • Built to strict quality control standards

This window motor makes a great replacement and has substantial cost savings over a dealer unit.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. Removing the Door Panel (0:55 in the video)
    • Disconnect the negative battery cable with a 10mm wrench
    • Pry off the speaker cover with a flat blade screwdriver
    • Remove two 10mm screws from the speaker
    • Remove the Phillips screw at the bottom of the door panel
    • Remove the two Phillips screws on the sides of the door panel
    • Remove the Phillips screw inside the door pull
    • Remove the Phillips screw inside the door handle
    • Pry out the door panel
    • Disconnect the lock rods from the door handle
    • Lift the door panel up and off
  2. Removing the Window Regulator (2:37 in the video)
    • Raise the window
    • Slowly pull the balancing spring back with a pair of pliers and remove it
    • Remove the two 10mm bolts from the window track
    • Remove the lower 10mm bolt from the regulator
    • Disconnect the window motor lead
    • Remove the four 10mm bolts from the regulator
    • Push the window down
    • Loosen the two 10mm bolts that hold the window to the regulator
    • Pull the regulator off the window
    • Raise the window by hand
    • Pull the window regulator out through the door
  3. Separating the Window Motor from the Regulator (6:05 in the video)
    • Remove the three 10mm bolts from the window motor
    • Pull the motor away from the regulator
  4. Installing the Motor (6:30 in the video)
    • Pull back the window motor bracket on the regulator
    • Put the motor onto the bracket
    • Insert the three 10mm bolts into the motor
  5. Reinstalling the Regulator (8:04 in the video)
    • Insert one of the bolts into the window regulator
    • Push the regulator into the door
    • Hang the regulator by its bolt
    • Insert the four 10mm bolts into the regulator
    • Connect the window switch wiring harness
    • Connect the window motor to the lead
    • Reconnect the battery
    • Turn the vehicle on
    • Run the motor up for 4 seconds
    • Disconnect the window motor lead
    • Lower the window onto the regulator
    • Insert the two 10mm bolts that hold the window to the regulator
    • Pull the balancing spring into place
    • Insert the two 10mm bolts into the window track
  6. Reinstalling the Door Panel (11:28 in the video)
    • Lift the door panel into place
    • Connect the lock rod to the door handle
    • Push in the door panel clips
    • Insert the Phillips screw inside the door pull
    • Insert the Phillips screw inside the door handle
    • Insert the Phillips screw at the bottom of the door panel
    • Insert the two Phillips screws on the sides of the door panel
    • Put the speaker into place
    • Insert two 10mm screws from the speaker
    • Reconnect the negative battery cable with a 10mm wrench

Tools needed for replacement:

    Pliers, Cutters & misc Wrenches

  • Needle nose pliers

  • Ratchets & Related

  • Ratchet
  • Socket Extensions

  • Screwdrivers & Related

  • Flat Blade Screwdriver
  • Phillips Head Screwdriver

  • Sockets - Metric

  • 10mm Socket

  • Wrenches - Metric

  • 10mm Wrench

How-to Video:

(13:23 min)

Tools List:

    Pliers, Cutters & misc Wrenches

  • Needle nose pliers

  • Ratchets & Related

  • Ratchet
  • Socket Extensions

  • Screwdrivers & Related

  • Flat Blade Screwdriver
  • Phillips Head Screwdriver

  • Sockets - Metric

  • 10mm Socket

  • Wrenches - Metric

  • 10mm Wrench



This part replaces:

  • HOLLANDER 617-00306L, 617-00323L
  • OE # 4624625
  • DORMAN 742-310

Vehicle Fit

  • 1995-1996 Chrysler Cirrus 9 Tooth Window Motor Front or Rear Driver Side
  • 1993-1997 Chrysler Concorde 9 Tooth Window Motor Front or Rear Driver Side
  • 1994-1997 Chrysler LHS 9 Tooth Window Motor Front or Rear Driver Side
  • 1994-1996 Chrysler New Yorker 9 Tooth Window Motor Front or Rear Driver Side
  • 1993-1997 Dodge Intrepid 9 Tooth Window Motor Front or Rear Driver Side
  • 1995-1996 Dodge Stratus 9 Tooth Window Motor Front or Rear Driver Side
  • 1993-1997 Eagle Vision 9 Tooth Window Motor Front or Rear Driver Side
  • 1996 Plymouth Breeze 9 Tooth Window Motor Front or Rear Driver Side
$50.45
Part #: 1AWPM00077

- Ships Same Day for orders placed by 5 P.M. ET

Free GROUND SHIPPING

Check Shipping Rates

We're here to help

Customer Feedback

Customer Feedback
"Thanks for the fast reliable service. Great price, and the headlights were as good as oem or better!!! Keep up the good work..."
- Dwuan M.
Read More
Free Shipping!
OR
CALL
TOLL
FREE

888-844-3393

hablamos Español:866-401-3393
SHIPS SAME DAY
For Orders Placed By 5pm Est