Replaces

1998-2004 Nissan Frontier Power Window Regulator with Motor Front Passenger Side

Part Details

  • Operation: Power
  • Location: Front
  • Location: Passenger Side

This part replaces:

  • PARTSLINK NI1351121
  • OE # 80720-3S525
  • HOLLANDER 125-58697R w/Motor
  • DORMAN 741-680

  • New

This replacement power window regulator with motor is just what you need to get your vehicle in good shape again!

Specifications:

  • Fits RH (Passenger Side) FRONT
  • Power operation
  • Replaces dealer part numbers: 80720-3S500, 80730-7B405, 807203S500, 807307B405
  • Includes power window motor
  • Direct replacement
  • Built to strict quality control standards

This window regulator makes a great replacement and has good cost savings over a dealer unit.

 

Please Note: This High Quality power window regulator is a new aftermarket replacement part that is built to strict quality control standards. It is far superior to the lower quality window regulators which have begun to appear on the internet. Although this window regulator is produced overseas, it was designed in the U.S. and the tooling is owned by a large U.S. manufacturer. That is why we guarantee this high quality window regulator with a superior warranty! If price is your main concern, we do offer the lower price overseas designed and built window regulator in our other listings.

Installation

  • This repair is easier than you may think. You'll find our installation videos helpful. In our experience removing and replacing the door panel is the most involved step in the repair. On most vehicles this only requires removing a few screws and push in clips.
  • You'll get a great feeling of accomplishment after you complete this repair knowing you saved money, and you didn't have to give up your car for a day at the repair shop. Your passengers and other drivers will be amazed.

Fit guaranteed

  • 1A Auto will refund you with no hassle, if this Window regulator does not fit the application stated.
    • You can use your existing hardware and wiring harnesses. This Regulator will install just as your original does. Save time and money.

Quality

  • Be confident this part will work right. Every regulator is tested after assembly to make sure all mechanisms are working correctly.
  • It is important that your new regulator works for a long period of time. The design of this regulator is tested to withstand 10,000 cycles. That is enough to raise and lower your window 3 times per day for 9 years.
  • Nothing is more frustrating than taking your car apart and finding the part you purchased does not fit. You want the part to fit. This design is test fit on an actual door. When you install it, you will have no issues.

Value

  • Windows that don't work can be frustrating. They can also hurt your vehicles value. An inoperable window could mean $200-$500 discounted off a dealer trade value or asking price.
  • Some shops and dealers charge more for parts and repairs when they think you don't know what is involved. Now you can get the value you deserve. Knowing what this repair entails can be the difference between the value of doing it yourself, or the pain of a costly repair bill.

 

Lifetime Warranty

Effective June 23, 2014: This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. Removing the Door Panel
    • Pry off the screw cover from the mirror base trim panel with a flat blade screwdriver
    • Remove the Phillips head screw from the door handle
    • Remove the Phillips screw from the door pull
    • Pull off the armrest
    • Remove the Phillips screw underneath the armrest
    • Remove the Phillips screw from the mirror base trim panel
    • Pull off the door pull panel
    • Disconnect the window switch wiring harnesses
    • Remove the Phillips screw behind the door pull
    • Pull the door panel off by hand
    • Remove the two Phillips screws from the door panel bracket
    • Carefully peel back the watershield
  2. Removing the Window Regulator
    • Remove the four 10mm bolts from the window regulator plate
    • Remove the two 10mm bolts that hold the window to the regulator
    • Lift the window by hand
    • Pull the window out of the door
    • Disconnect the window motor wiring harness
    • Remove three of the four 10mm bolts from the window regulator
    • Loosen the remaining 10mm bolt from the regulator
    • Remove the three 10mm bolts from the window motor
    • Pull the regulator out of the door
  3. Installing the New Window Regulator
    • Start one bolt into the new regulator
    • Slide the new regulator into the door
    • Hang the regulator in place by its bolt
    • Hang the motor by its tabs
    • Pull the wiring harness through its cavity
    • Start the three remaining 10mm regulator bolts
    • Start the three 10mm bolts into the window motor
    • Tighten the seven 10mm bolts
    • Feed the window into the door starting at the front
    • Lower the window onto the regulator
    • Insert the two 10mm bolts that hold the window to the regulator
    • Connect the window motor wiring harness
    • Clip the window motor wiring harness into place
    • Put the regulator plate into place
    • Insert the four 10mm bolts into the regulator plate
  4. Reinstalling the Door Panel
    • Put the watershield into place
    • Put the door panel bracket into place
    • Insert the two Phillips screws into the door panel bracket
    • Lift the door panel into place
    • Pull the wiring harnesses through their cavities
    • Push in the door panel clips
    • Insert the Phillips screw into the door handle
    • Insert the Phillips screw behind the door pull
    • Insert the Phillips screw behind the arm rest
    • Insert the Phillips screw into the mirror base trim piece
    • Push on the screw cover in the mirror base trim piece
    • Connect the window switch wiring harnesses
    • Push the door pull panel into place
    • Push the arm rest panel into place
    • Insert the Phillips screw into the door pull

How-to Video:

(08:14 min)

Tools List:

    Ratchets & Related

  • Ratchet

  • Screwdrivers & Related

  • Flat Blade Screwdriver
  • Phillips Head Screwdriver

  • Sockets - Metric

  • 10mm Socket

  • Wrenches - Metric

  • 10mm Wrench



This part replaces:

  • PARTSLINK NI1351121
  • OE # 80720-3S525
  • HOLLANDER 125-58697R w/Motor
  • DORMAN 741-680

Vehicle Fit

  • 1998-2004 Nissan Frontier Power Window Regulator with Motor Front Passenger Side
  • 2000-2004 Nissan Xterra Power Window Regulator with Motor Front Passenger Side
$60.45
Part #: 1AWRG00602

- Ships Same Day for orders placed by 5 P.M. ET

Free GROUND SHIPPING

Check Shipping Rates

We're here to help

Customer Feedback

Customer Feedback
"Thanks for the fast reliable service. Great price, and the headlights were as good as oem or better!!! Keep up the good work..."
- Dwuan M.
Read More
Free Shipping!
OR
CALL
TOLL
FREE

888-844-3393

hablamos Español:866-401-3393
SHIPS SAME DAY
For Orders Placed By 5pm Est