Replaces

2007-2010 Ford Explorer Sport Trac Power Heated Puddle Light with Chrome & PTM Caps Mirror Driver Side

Part Details

  • Operation: Power
  • Side Location: Driver Side
  • Mirror Options: Heated
  • Mirror Options: Puddle Light
  • Mirror Options: Chrome & Paintable Caps

This part replaces:

  • HOLLANDER 128-00937BL
  • PARTSLINK FO1320284
  • OE # 615343106595
  • OE # 6L2Z17683EAA

  • New

This replacement mirror is just what you need to get your vehicle in good looking form again!

This mirror features the following specifications:

  • LH (driver's side)
  • Power operation
  • Heated
  • Has puddle light
  • Body of mirror is textured black
  • Cover or backing comes in 2 Styles which buyer can decide on which ti install
    • (PTM) Paint to match or a Smooth Flat Black Cap
    • Chrome Cover
  • Replaces dealer part numbers: 6L2Z 17683 EAA, 6153 431065 95, 6L2Z17683EAA, 615343106595
  • Direct bolt on
  • Built to strict quality control standards
  • Manual folding
  • Does not have integrated turn signal

This truck mirror makes a great replacement and has substantial cost savings over a dealer unit.

Paint To Match Note:

Paint to match finish refers to a smooth, paintable surface.  This item will be shipped unpainted, but ready for paint.  Final preparation is suggested for better paint coverage and adhesion. 

Special Note:

  • This mirror is designed to replace an original mirror with these exact options. If you do not have the options listed, there is a possibility that this mirror may not function properly.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. Removing the Mirror Glass (0:32)
    • Push the mirror glass to the side to access behind it
    • Loosen the tabs holding the mirror glass
    • Remove the mirror glass
  2. Removing the Mirror Cap (1:29)
    • Pry out from the corner of the side view mirror cap
    • Pry up on the tab holding the cap in on the mirror
  3. Removing the Door Panel (2:22)
    • Pry off the side trim piece next to the window switch panel with a rag and flat blade screwdriver
    • Pry up the window switch panel with a flat blade screwdriver
    • Disconnect the wiring harnesses
    • Pry off the trim piece from the pull handle
    • Remove the two 7mm bolts in the switch
    • Remove the two 7mm bolts in the door pull
    • Remove the two 7mm bolts on the bottom of the door panel
    • Pry off the mirror switch with a flat blade screwdriver
    • Disconnect the mirror switch wiring harness
    • Pull the door panel up and off
    • Disconnect the door lock cable with a flat blade screwdriver
    • Remove four 6mm screws from the speaker
    • Disconnect the speaker wiring lead
    • Pull off the speaker
    • Carefully peel back the water shield
  4. Removing the Side Rear View Mirror (5:14)
    • Remove the insulation from the mirror base
    • Remove the three 11mm nuts from the mirror
    • Firmly hit the mirror to release it from its clip
    • Remove the mirror
  5. Installing the Side Rear View Mirror (6:15)
    • Insert the mirror into place
    • Insert the 11mm bolts to the mirror
    • Tighten the bolts to the mirror
    • Connect the mirror wiring harness
    • Push on the insulation
  6. Installing the Mirror Cap (7:03)
    • Push the mirror cap down on the mirror
    • Slide the mirror back to engage the tabs
  7. Reinstalling the Door Panel (8:15)
    • Put the speaker into place
    • Connect the speaker wiring lead
    • Insert the four 6mm bolts into the speaker
    • Put the water shield into place
    • Connect the door lock cable to the door handle
    • Lift the door panel into place
    • Push in the door panel clips
    • Lightly tighten the two 7mm bolts on the bottom of the door panel
    • Tighten the two 7mm bolts in the switch
    • Tighten the two 7mm bolts in the door pull
    • Connect the mirror switch wiring harness
    • Push the mirror switch into place
    • Connect the wiring harnesses to the window switch panel
    • Push the window switch panel into place
    • Push on the trim piece next to the window switch panel
    • Push on the door pull trim piece

Tools needed for replacement:

    Ratchets & Related

  • Socket Extensions

  • Screwdrivers & Related

  • Flat Blade Screwdriver

  • Sockets - Metric

  • 11mm Socket
  • 7mm Socket
  • 6mm Socket

5.0 / 5.0
1 Review
5 Stars
4 Stars
3 Stars
2 Stars
1 Star
1
0
0
0
0
Great transaction, excellent service
September 26, 2013
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

How-to Video:

(11:08 min)

Tools List:

    Ratchets & Related

  • Socket Extensions

  • Screwdrivers & Related

  • Flat Blade Screwdriver

  • Sockets - Metric

  • 11mm Socket
  • 7mm Socket
  • 6mm Socket



This part replaces:

  • HOLLANDER 128-00937BL
  • PARTSLINK FO1320284
  • OE # 615343106595
  • OE # 6L2Z17683EAA

Vehicle Fit

  • 2006-2010 Ford Explorer Power Heated Puddle Light with Chrome & PTM Caps Mirror Driver Side
  • 2007-2010 Ford Explorer Sport Trac Power Heated Puddle Light with Chrome & PTM Caps Mirror Driver Side
  • 2006-2010 Mercury Mountaineer Power Heated Puddle Light with Chrome & PTM Caps Mirror Driver Side
$153.95
Save 9%
List: $168.52 Save: $14.57
Only 3 left in stock
Part #: 1AMRE01914

Ships Same Day for orders placed by 5 P.M. ET

Free GROUND SHIPPING

Check Shipping Rates

We're here to help

1A Auto Parts

Customer Feedback

Customer Feedback
"Thanks for the fast reliable service. Great price, and the headlights were as good as oem or better!!! Keep up the good work..."
- Dwuan M.
Read More
Free Shipping!
OR
CALL
TOLL
FREE

888-844-3393

hablamos Español:866-401-3393
SHIPS SAME DAY
For Orders Placed By 5pm Est