Replaces

1980-1985 Cadillac Seville Idler Arm

  • New

Your idler arm connects to the center link on the passenger side of your steering linkage. Typically it supports the right hand side of your steering linkage by bolting to the frame and pivoting the same as the pitman arm. Over time the greasable ends and even the holes in the arm can wear causing loose connections and a sloppy steering feel.

Specifications:

  • Includes (1) Idler Arm assembly as shown
  • Replaces dealer part numbers: 26029949, 26033093, 26054932, 7830667, 7833124, 7837636
  • Comes as shown with greasable end
  • Direct replacement
  • Built to strict quality control standards

Remember whenever you are replacing any front end or steering components you should have your vehicle professionally aligned as soon as possible.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. Clean up the top of the upper control arm (1:00)
  2. Install the ball joint (1:07)
    • Line up the boot on the ball joint and put the ball joint in place and put the nut on it.
    • Bolt the ball joint in with the four nuts and bolts.
    • Torque them to 25 ft lbs
  3. Install the tie rod. (2:18)
    • Put the tie rod in place
    • Bolt it in at 55 ft lbs.
    • Put in the cotter pin, hammer it through and bend it with a pair of pliers.
    • Fill the tie rod end with grease.
  4. Install the hub (3:35)
    • Put the O ring into the hub.
    • Mount the hub and thread the ABS harness into place.
    • Bolt the hub into place and make sure the shield is in the correct position.
    • Use a star like pattern when bolting in the hub and torque the bolts to 65 ft lbs.
    • Clip and bolt the ABS harness in and connect it.
  5. Install the brakes (6:05)
    • Mount the rotor and caliper
    • Bolt the caliper bolts in and torque to 50-60 ft lbs.
    • Use a rubber mallet to help get the caliper on.
  6. Install the hub nut and wheel. (7:00)
    • Before putting the wheel on, put the hub nut on and tighten but do not torque.
    • Put the wheel back on and lower the car.
    • Torque the hub nut to 90 ft lbs.
    • Using a star pattern, torque the wheel lug nuts to 75 ft lbs.
    • Put the cap and lug nut covers on.

Tools needed for replacement:

    General Tools

  • Chisel
  • Floor Jack
  • Hammer
  • Jack Stands
  • Rubber Mallet

  • Materials, Fluids, and Supplies

  • Rust Penetrant

  • Ratchets & Related

  • Ratchet
  • Socket Extensions
  • Torque Wrench

  • Screwdrivers & Related

  • Flat Blade Screwdriver
  • Pry Bar

  • Sockets - Metric

  • 10mm Socket
  • 11mm Socket
  • 12mm Socket
  • 13mm Socket
  • 14mm Socket
  • 15mm Socket
  • 16mm Socket
  • 17mm Socket
  • 18mm Socket
  • 19mm Socket
  • 20mm Socket
  • 21mm Socket
  • 22mm Socket
  • 24mm Socket
  • 35mm Socket

  • Specialty Tools

  • Grease Gun

  • Wrenches - Metric

  • 13mm Wrench
  • 18mm Wrench

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

How-to Video:

(09:04 min)

Tools List:

    General Tools

  • Chisel
  • Floor Jack
  • Hammer
  • Jack Stands
  • Rubber Mallet

  • Materials, Fluids, and Supplies

  • Rust Penetrant

  • Ratchets & Related

  • Ratchet
  • Socket Extensions
  • Torque Wrench

  • Screwdrivers & Related

  • Flat Blade Screwdriver
  • Pry Bar

  • Sockets - Metric

  • 10mm Socket
  • 11mm Socket
  • 12mm Socket
  • 13mm Socket
  • 14mm Socket
  • 15mm Socket
  • 16mm Socket
  • 17mm Socket
  • 18mm Socket
  • 19mm Socket
  • 20mm Socket
  • 21mm Socket
  • 22mm Socket
  • 24mm Socket
  • 35mm Socket

  • Specialty Tools

  • Grease Gun

  • Wrenches - Metric

  • 13mm Wrench
  • 18mm Wrench




Vehicle Fit

  • 1979-1985 Buick Riviera Idler Arm
  • 1979-1985 Cadillac Eldorado Idler Arm
  • 1980-1985 Cadillac Seville Idler Arm
  • 1983-2005 Chevy Blazer S10 4WD Idler Arm
  • 1983-2004 Chevy S10 Pickup 4WD Idler Arm
  • 1998-2000 GMC Envoy Idler Arm
  • 1983-2001 GMC Jimmy S-15 4WD Idler Arm
  • 1983-1990 GMC S-15 Pickup 4WD Idler Arm
  • 1991-2004 GMC S-15 Sonoma 4WD Idler Arm
  • 1991 GMC Syclone Idler Arm
  • 1992-1993 GMC Typhoon Idler Arm
  • 1996-2000 Isuzu Hombre 4WD Idler Arm
  • 1991-2001 Olds Bravada Idler Arm
  • 1979-1985 Olds Toronado Idler Arm
$40.95
Part #: 1ASIA00003

Ships Same Day for orders placed by 5 P.M. ET

Free GROUND SHIPPING

Check Shipping Rates

We're here to help

1A Auto Parts

Customer Feedback

Customer Feedback
"Thanks for the fast reliable service. Great price, and the headlights were as good as oem or better!!! Keep up the good work..."
- Dwuan M.
Read More
Free Shipping!
OR
CALL
TOLL
FREE

888-844-3393

hablamos Español:866-401-3393
SHIPS SAME DAY
For Orders Placed By 5pm Est