How To Replace Blower Motor Resistor 2004-10 Ford F150
Created on: 2014-11-19
Easily replace the blower motor fan speed resistor on your 04-10 Ford F150 by following the detailed step-by-step instructions in this video from 1A Auto.
-
step 1 :Removing the Blower Motor Resistor
- Open the glove box
- Push in the glove box wall on the passenger side
- Pull down the glove box
- Disconnect the blower motor resistor wiring harness
- Remove the two 8mm bolts from the blower motor resistor
- Pull out the resistor
- Pull out the gasket
-
step 2 :Installing the Blower Motor Resistor
- Put the gasket into place on the resistor
- Put the resistor into place
- Insert the two 8mm bolts into the resistor
- Connect the resistor wiring harness
- Close the glove box
Tools needed
-
8mm Socket
Ratchet
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Mike from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks.
In this video, we're going to show you how to replace the blower motor resistor on this 2005 Ford F150. It's the same part and similar process on these F150s from 2004 to 2010. The items you'll need for this is new blower motor resistor from 1AAuto.com and an 8 millimeter socket and ratchet.
Open up your glove box and just push in on the passenger's side and pull it down. Now, push the tab on the bottom of this harness and then just pull it free. Then remove these two 8 millimeter bolts. We'll fast forward as Mike does that. You can use an air ratchet for this, just to speed up the process. Once you remove the bolts, it pulls right out. Then, you just want to pull off this gasket as well.
On the left is the old blower motor resistor. On the right is the new one from 1AAuto. You can see they're identical and they'll fit exactly the same. Make sure the gasket's in place, and then feed your blower motor resistor back into place. Then, replace those two 8 millimeter bolts by hand. One corner is notched and there's a tab in it, so you can only put it in one way. Tighten up the bolts, careful not to over-tighten them. You don't want to strip out the plastic. Reconnect your harness and then push in the side of your glove box and close it.
We hope this video helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free, 888-844-3393. We're the company that's here for you on the Internet and in person.
Shop Products
Ford Lincoln Mercury Blower Motor Resistor TRQ HCA40089
- Highest Quality Materials
- Quality Tested - built to a strict level of product standards.
How to Replace Blower Motor Resistor 2004-10 BMW X3
This video shows you how to install a new blower motor resistor on your 2003-10 BMW X3.
