1999-2003 Ford F550 Truck Super Duty Power Window Regulator with Motor Front Pair

Part Details

  • Window Options: with Motor
  • Operation: Power
  • Location: Front
  • Quantity: Pair

This part replaces:

  • OE # 8C3Z-2523201-C,6C3Z-2523200-BA

  • New

These replacement window regulators are just what you need to get your vehicle in good shape again!


  • Comes as a PAIR
    • Fits both the LH (Driver Side) & RH (Passenger Side) FRONT
  • Includes the Power Window Motors
  • Replaces dealer part numbers: 8C3Z-2523201-C, 8C3Z2523201C, F81Z-2523201-BA, F81Z2523201BA, XC3Z-2523201-BB, XC3Z2523201BB, 1C3Z-2523201-BA, 1C3Z2523201BA, 6C3Z-2523209-AA, 6C3Z2523209AA, F81Z-15233V95-BARM, F81Z15233V95BARM, F81Z-15233V95-AARM, F81Z15233V95AARM, 6C3Z-2523200-BA, 6C3Z2523200BA
  • Power operation
  • Direct replacements
  • Built to strict quality control standards
  • LH (Driver Side) assembly works for models with or without Autodown Feature

Note: For 1999 model trucks, there were two options for window motor plugs: vertical or horizontal pin. The plug on these motors have horizontal pins. If your vehical has vertical pins, these assemblies will work if you swap the plugs from your original.

These window regulators make good replacements and have substantial cost savings over the dealer units.

Please Note: This High Quality power window regulator is a new aftermarket replacement part that is built to strict quality control standards. It is far superior to the lower quality window regulators which have begun to appear on the internet. Although this window regulator is produced overseas, it was designed in the U.S. and the tooling is owned by a large U.S. manufacturer. That is why we guarantee this high quality window regulator with a superior warranty! If price is your main concern, we do offer the lower price overseas designed and built window regulator in our other listings.


  • This repair is easier than you may think. You'll find our installation videos helpful. In our experience removing and replacing the door panel is the most involved step in the repair. On most vehicles this only requires removing a few screws and push in clips.
  • You'll get a great feeling of accomplishment after you complete this repair knowing you saved money,and you didn't have to give up your car for a day at the repair shop. Your passengers and other drivers will be amazed.

Fit guaranteed

  • 1A Auto will refund you with no hassle, if this Window regulator does not fit the application stated.
  • You can use your existing hardware and wiring harnesses. This Regulator will install just as your original does. Save time and money.


  • Be confident this part will work right. Every regulator is tested after assembly to make sure all mechanisms are working correctly.
  • It is important that your new regulator works for a long period of time. The design of this regulator is tested to withstand 10,000 cycles. That is enough to raise and lower your window 3 times per day for 9 years.
  • Nothing is more frustrating than taking your car apart and finding the part you purchased does not fit. You want the part to fit. This design is test fit on an actual door. When you install it, you will have no issues.


  • Windows that don't work can be frustrating. They can also hurt your vehicles value. An inoperable window could mean $200-$500 discounted off a dealer trade value or asking price.
  • Some shops and dealers charge more for parts and repairs when they think you don't know what is involved. Now you can get the value you deserve. Knowing what this repair entails can be the difference between the value of doing it yourself, or the pain of a costly repair bill.

Lifetime Warranty

Effective June 23, 2014: This item is backed by a manufacturer's Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. Disconnecting the Battery
    • Disconnect the negative battery cable with an 8mm wrench
  2. Removing the Door Panel
    • Pry off the courtesy light with a flat blade screwdriver
    • Pry off the window switch panel with a flat blade screwdriver
    • Disconnect the window switch wiring harnesses
    • Pull the window base trim panel off by hand
    • Remove the 7mm bolt behind the courtesy light
    • Remove the 7mm bolt behind the window switch
    • Lift the door panel up and off
    • Twist the courtesy light socket counterclockwise and pull it out
    • Remove the 7/32 inch bolts from the speaker
    • Disconnect the speaker wiring harness
    • Peel off the water shield
  3. Removing the Window Regulator
    • Disconnect the window motor lead
    • Remove the four bolts from the regulator
    • Remove the two nuts from the window track
    • Pull the window down by hand
    • Remove two nuts from the window track
    • Slide the track forward and away from the window
    • Pull the window up by hand
    • Hold the window in place with painter’s tape
    • Pull the regulator out of the door
  4. Installing the New Window Regulator
    • Start all the nuts and bolts into the new regulator
    • Fold the new regulator into the proper position
    • Slide the new regulator into the door
    • Hang the regulator by its bolts
    • Tighten the regulator nuts and bolts
    • Connect the window motor wiring harness, keeping the harness away from the window
    • Reconnect the negative battery cable
    • Connect the window wiring harness
    • Turn the ignition on
    • Move the regulator up with the window switch
    • Turn the ignition off
    • Disconnect the window switch wiring harness
    • Remove the painter’s tape from the window
    • Lower the window by hand
    • Lower the window into the track
    • Tighten the two nuts into the window track
    • Turn the ignition on
    • Connect the window switch wiring harness
    • Test that the window works with the window switch
  5. Reinstalling the Door Panel
    • Put the water shield into place
    • Connect the speaker wiring harness
    • Push the speaker into place
    • Insert the 7/32 inch bolts into the speaker
    • Put the door panel in place using the bottom clips
    • Twist the courtesy light socket clockwise into place
    • Pull the wiring harnesses through their cavity
    • Push the door panel into place
    • Push in the door panel clips
    • Insert the 7mm screw behind the window switch panel
    • Insert the 7mm screw behind the courtesy light
    • Push the mirror base molding into place
    • Connect the wiring harnesses to the window switch panel
    • Push the window switch panel into place
    • Push the courtesy light into place
  6. Reconnecting the Battery
    • Reconnect the negative battery cable if you have not yet done so

How-to Video:

(13:36 min)

Tools List:

    Materials, Fluids, and Supplies

  • Painter's Tape

  • Ratchets & Related

  • Ratchet
  • Socket Extensions

  • Screwdrivers & Related

  • Flat Blade Screwdriver

  • Sockets - Metric

  • 10mm Socket
  • 7mm Socket
  • 8mm Socket

  • Sockets - SAE

  • 7/32 Inch Socket

This part replaces:

  • OE # 8C3Z-2523201-C,6C3Z-2523200-BA

Vehicle Fit

  • 2000-2005 Ford Excursion Power Window Regulator with Motor Front Pair
  • 1999-2012 Ford F250 Super Duty Truck Power Window Regulator with Motor Front Pair
  • 1999-2012 Ford F350 Super Duty Truck Power Window Regulator with Motor Front Pair
  • 1999-2003 Ford F450 Truck Super Duty Power Window Regulator with Motor Front Pair
  • 1999-2003 Ford F550 Truck Super Duty Power Window Regulator with Motor Front Pair
Part #: 1AWRK00527

- Ships Same Day for orders placed by 5 P.M. ET


Check Shipping Rates

We're here to help

Customer Feedback

Customer Feedback
"Thanks for the fast reliable service. Great price, and the headlights were as good as oem or better!!! Keep up the good work..."
- Dwuan M.
Read More
Free Shipping!


hablamos Español:866-401-3393
For Orders Placed By 5pm Est