Replaces

2003-2003 Ford E550 Van Super Duty Power Window Motor Front Passenger Side

This part replaces:

  • HOLLANDER 617-00287R, 617-00369R,-00264L
  • DORMAN 742-235
  • OE # 1C2Z1523200AA, F1TZ78233V95BRM

  • New

This power window motor is just what you need to get your vehicle in good shape again! If your window regulator is good, but the motor is burned out, then this is the part for you.

Specifications:

  • Either LH (Driver Side) or RH (Passenger Side) FRONT or REAR as listed by application
  • Brand New
    • No core charge
  • Replaces dealer part numbers: 1C2Z-1523200-AA, F1TZ-78233V95-BRM, 1C2Z1523200AA, F1TZ78233V95BRM
  • Direct replacement
  • Built to strict quality control standards

This window motor makes a great replacement and has good cost savings over a dealer unit.

Lifetime Warranty

Effective June 23, 2014: This item is backed by a manufacturer's Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. Removing the Door Panel
    • Use a flat blade screwdriver to pry off the bezel inside the door pull
    • Use a flat blade screwdriver to pry off the bezel inside the door handle
    • Remove the Phillips head screw inside the door handle
    • Remove the Phillips head screw inside the door pull
    • Remove the three Phillips head screws alongside the bottom of the door panel
    • Remove the Phillips head screw at the back of the door panel
    • Pull off the mirror base trim
    • With a putty knife pry off the door panel
    • Disconnect the door lock wiring harness
    • Disconnect the latch rod from the door handle
    • Disconnect the power window switch wiring harness
    • If any pins remain in the door, remove them with needle nose pliers
    • Reinstall those pins into the door panel
  2. Removing the Window Regulator
    • Carefully pull back the water shield, avoiding tearing it
    • Remove the six 10mm nuts that hold the regulator to the door
    • Pull the window down partially by hand
    • Loosen the two 10mm nuts on the window track
    • Remove the window from the window track
    • Pull the window up by hand
    • Pull the window regulator partially out
    • Disconnect the window motor wiring harness
  3. Detaching the Window Motor from the Window Regulator
    • Remove the three T25 Torx screws that hold the motor to the regulator
    • Detach the motor from the regulator
  4. Attaching the New Motor to the Regulator
    • Line up the motor and regulator gears
    • Push the motor into place
    • Start the three screws by hand
    • Tighten the three T25 Torx screws
  5. Reattaching the Window Regulator
    • Connect the window motor to its wiring harness
    • Connect the window switch to its wiring harness
    • Turn the regulator down slightly, using the window switch
    • Insert the regulator into the door
    • Put the regulator into place
    • Start all the nuts and bolts by hand
    • Tighten all the nuts and bolts
    • Move the regulator into place with the window switch
    • Disconnect the wiring harness from the window switch
    • Slide the window onto the window track
    • Tighten the 10mm nuts on the window track
    • Carefully put the water shield back into place
  6. Reinstalling the Door Panel
    • Reconnect the wiring harness to the window switch
    • Check that the window regulator and motor function properly
    • Reconnect the door lock switch
    • Clip the latch rod to the door handle
    • Slide the door panel into place
    • Push the door panel locating tab into its hole
    • Push the pins in
    • Insert the Phillips screw into the door pull
    • Insert the Phillips screw into the door handle
    • Insert the three Phillips screws along the bottom of the door panel
    • Insert the Phillips screw at the back of the door panel
    • Push the mirror base trim back into place
    • Put the bezel back into the door handle
    • Put the bezel back into the door pull

How-to Video:

(13:35 min)

Tools List:

    Pliers, Cutters & misc Wrenches

  • Needle nose pliers

  • Ratchets & Related

  • Ratchet
  • Socket Extensions

  • Screwdrivers & Related

  • Flat Blade Screwdriver
  • Phillips Head Screwdriver

  • Sockets - Metric

  • 10mm Socket

  • Specialty Tools

  • Door Panel Removal Tool
  • Flashlight
  • Putty Knife

  • Torx Drivers & Sockets

  • T30 Torx Driver



This part replaces:

  • HOLLANDER 617-00287R, 617-00369R,-00264L
  • DORMAN 742-235
  • OE # 1C2Z1523200AA, F1TZ78233V95BRM

Vehicle Fit

  • 1992-2013 Ford E150 Van Power Window Motor Front Passenger Side
  • 1992-2013 Ford E250 Van Power Window Motor Front Passenger Side
  • 1992-2013 Ford E350 Van Power Window Motor Front Passenger Side
  • 2003-2013 Ford E450 Van Super Duty Power Window Motor Front Passenger Side
  • 2003 Ford E550 Van Super Duty Power Window Motor Front Passenger Side
  • 1991-1994 Ford Explorer Power Window Motor Rear Driver Side
$64.95
Save 45%
List: $117.98 Save: $53.03
Part #: 1AWPM00177

- Ships Same Day for orders placed by 5 P.M. ET

Free GROUND SHIPPING

Check Shipping Rates

We're here to help

Customer Feedback

Customer Feedback
"Thanks for the fast reliable service. Great price, and the headlights were as good as oem or better!!! Keep up the good work..."
- Dwuan M.
Read More
Free Shipping!
OR
CALL
TOLL
FREE

888-844-3393

hablamos Español:866-401-3393
SHIPS SAME DAY
For Orders Placed By 5pm Est