Replaces
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
Returns: Parts with electrical components cannot be returned once installed.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Mike from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks.
In this video, we're going to show you how to replace the EGR Vacuum Modulator on this 2003 Mercury Mountaineer. It's the same part and similar process on these Mountaineers from 2002 to 2003. The items you'll need for this is a new EGR valve vacuum modulator from 1AAuto.com, and an 8mm socket and ratchet.
Start off by lifting up on these clips and pulling them back. Then slide the top of your air intake box off. Pull out the air filter. Then lift up on the bottom of your air intake box, maneuver it free, and lift it up and out.
The vacuum modulator is located right here. Push the tab on the harness and disconnect it. Then you want to remove this 8mm nut, and this 8mm nut from the other side. We'll fast forward as Mike removes both of those. Now pull it from the studs, and then pull your two hoses free.
On the left is the old EGR valve vacuum modulator. On the right is the new one from 1A Auto. You can see they're identical and they'll fit exactly the same. Take your new EGR valve vacuum modulator and reconnect those two hoses, and then connect the harness. Then push the modulator onto those two studs, and replace those two 8mm nuts and tighten them up.
On the lower part of your air intake box, you want to push those two legs into those two holes. Just feed it down into place. Then push those two back clips into the side of the vehicle, and then push the two legs on the bottom down into the holes. Make sure it's all the way down. Then replace your air filter. Then replace the top of the air intake box and just slide those tabs back into the side. Then reclip the top of the air intake box down.
We hope this video helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free, 888-844-3393. We're the company that's here for you on the Internet and in person.
Tools used
Tools used
