Replaces

2006-2007 Chevy Malibu Power Window Regulator with Motor Rear Door Pair

Part Details

  • Window Options: with Motor
  • Operation: Power
  • Location: Rear
  • Quantity: Pair

  • New

These replacement window regulators are just what you need to get your vehicle in good shape again!

Specifications:

  • Comes as a PAIR
    • Fits both LH (Driver Side) & RH (Passenger Side) REAR
  • Include the power window motors
  • Replaces dealer part numbers: 15781321, 15781320
  • Power operation
  • Direct replacements
  • Built to strict quality control standards
  • 2008 Classic models have an emblem in the grille

For vehicles needing info with a VIN code: You can find your vehicles VIN (vehicle identification number) in the driver's side lower corner of the windshield near the A pillar, on your title, or on your state registration.

These window regulators make great replacements and have good cost savings over dealer units.

Installation:

  • This repair is easier than you may think. You'll find our installation tips helpful. In our experience removing and replacing the door panel is the most involved step in the repair. On most vehicles this only requires removing a few screws and push in clips.
  • You'll get a great feeling of accomplishment after you complete this repair knowing you saved money and you didn't have to give up your car for a day at the repair shop. Your passengers and other drivers will be amazed.

Fit guaranteed

  • 1A Auto will refund you with no hassle, if this Window regulator does not fit the application stated.
    • You can use your existing hardware and wiring harnesses. This Regulator will install just as your original does. Save time and money.

Quality

  • Be confident this part will work right. Every regulator is tested after assembly to make sure the cables and all mechanisms are working correctly.
  • It is important that your new regulator works for a long period of time. The design of this regulator is tested to withstand 10,000 cycles. That is enough to raise and lower your window 3 times per day for 9 years.
  • Nothing is more frustrating than taking your car apart and finding the part you purchased does not fit. You want the part to fit. This design is test fit on an actual door. When you install it you will have no issues.

Value

  • Windows that don't work can be frustrating. They can also hurt your vehicles value. An inoperable window could mean $200-$500 discounted off a dealer trade value or asking price.
  • Some shops and dealers charge more for parts and repairs when they think you don't know what is involved. Now you can get the value you deserve. Knowing what this repair entails can be the difference between the value of doing it yourself, or the pain of a costly repair bill.

 

Please Note: This High Quality power window regulator is a new aftermarket replacement part that is built to strict quality control standards. It is far superior to the lower quality window regulators which have begun to appear on the internet. Although this window regulator is produced overseas, it was designed in the U.S. and the tooling is owned by a large U.S. manufacturer. That is why we guarantee this high quality window regulator with a superior warranty! If price is your main concern, we do offer the lower price overseas designed and built window regulator in our other listings.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. Removing the Door Panel (0:58 in the video)
    • Remove the door handle bezel with a flat blade screwdriver
    • Pry off the trim piece inside the door pull with a flat blade screwdriver
    • Remove the two T25 Torx screws inside the door pull
    • Push the push pins on the back of the panel
    • Remove the pins by hand or flat blade screwdriver
    • Pry out the door panel with a door panel clip tool or putty knife
    • Pry off the mirror base trim piece by hand
    • Lift the door panel up and off
    • Disconnect the window switch wiring harness
    • Carefully peel off the water shield
  2. Removing the Window Regulator (4:46 in the video)
    • Adjust the window close to down but not all the way
    • Push out the middle of the barrel behind the wire with a flat blade screwdriver
    • Remove the middle sleeve of the barrel
    • Push the larger barrel out
    • Raise the window by hand
    • Hold the window in place with painter's tape
    • Disconnect the window motor lead
    • Remove the three 10mm bolts from the regulator and motor assembly
    • Bring the window down
    • Push the smaller barrel into the window slot with the marking on the backside
    • Push the larger barrel into the window slot with the tapered side on the backside
    • Squeeze the barrels together with pliers
    • Raise the window
    • Hold the window in place with painter's tape
  3. Installing the New Regulator (9:03 in the video)
    • Insert one of the bolts into the window regulator
    • Push the regulator into the door
    • Hang the regulator by its bolt
    • Tighten the three 10mm bolts into the regulator and motor assembly
    • Slowly lower the window onto the regulator, clip and lock it
    • Reconnect the window switch wiring harness
    • Test the window
  4. Reinstalling the Door Panel (10:07 in the video)
    • Put the water shield into place
    • Lift the door panel into place
    • Connect the lock rod to the door handle
    • Re-clip the door handle bezel
    • Replace the push pins on the back of the panel
    • Insert the two T25 Torx screws inside the door pull
    • Replace piece inside the door pull

Tools needed for replacement:

    Materials, Fluids, and Supplies

  • Painter's Tape

  • Pliers, Cutters & misc Wrenches

  • Channel-Lock Pliers

  • Ratchets & Related

  • Ratchet

  • Screwdrivers & Related

  • Flat Blade Screwdriver

  • Sockets - Metric

  • 10mm Socket

  • Specialty Tools

  • Flashlight
  • Putty Knife

  • Torx Drivers & Sockets

  • T25 Torx Driver

  • Wrenches - Metric

  • 10mm Wrench

How-to Video:

(11:57 min)

Tools List:

    Materials, Fluids, and Supplies

  • Painter's Tape

  • Pliers, Cutters & misc Wrenches

  • Channel-Lock Pliers

  • Ratchets & Related

  • Ratchet

  • Screwdrivers & Related

  • Flat Blade Screwdriver

  • Sockets - Metric

  • 10mm Socket

  • Specialty Tools

  • Flashlight
  • Putty Knife

  • Torx Drivers & Sockets

  • T25 Torx Driver

  • Wrenches - Metric

  • 10mm Wrench




Vehicle Fit

  • 2005 Chevy Malibu Power Window Regulator with Motor ( 4th Vin Digit Z) Rear Door Pair
  • 2006-2007 Chevy Malibu Power Window Regulator with Motor Rear Door Pair
  • 2008 Chevy Malibu Power Window Regulator with Motor for Classic Models Rear Door Pair
  • 2005 Chevy Malibu Maxx Power Window Regulator with Motor ( 4th Vin Digit Z) Rear Door Pair
  • 2006-2007 Chevy Malibu Maxx Power Window Regulator with Motor Rear Door Pair
$125.95
Save 63%
List: $343.28 Save: $217.33
Part #: 1AWRK00759

- Ships Same Day for orders placed by 5 P.M. ET

Free GROUND SHIPPING

Check Shipping Rates

We're here to help

Customer Feedback

Customer Feedback
"Thanks for the fast reliable service. Great price, and the headlights were as good as oem or better!!! Keep up the good work..."
- Dwuan M.
Read More
Free Shipping!
OR
CALL
TOLL
FREE

888-844-3393

hablamos Español:866-401-3393
SHIPS SAME DAY
For Orders Placed By 5pm Est