Replaces

1978-1986 Chevy C10 Truck Brake Drum & Shoe Set Rear for 11-1/8 x 2-3/4 Inch Drum

  • New

This REAR brake drum & shoe SET is just what you need to get your vehicle stopping in good order again!

Rear Drum Specifications::

  • Comes as a PAIR
  • Fits both the LH (Driver) & RH (Passenger Side) REAR
  • Replaces dealer part number: 14070351
  • Direct replacement
  • 6 wheel stud holes
  • Drum Size: 11-1/8 x 2-3/4 Inches
  • Fits 2WD Models only

Rear Brake Shoe Specifications:

  • Comes as a Set of 4 Shoes
    • Fits both the LH (Driver) & RH (Passenger Side) REAR
  • Premium Bonded Brake Shoes
  • No core charge
  • Direct replacement
  • Correct for: 11-1/8 x 2-3/4 Inch Drum

Note: This set contains enough pieces to do both sides on one rear axle - (2) rear brake drums & (1) rear brake shoe set.

This REAR brake drum & shoe SET makes a great replacement and has an excellent value over the price of dealer shoes & brake drums.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. Removing The Wheel and Tire (1:19 in the video)
    • Loosen the lug nuts
    • Raise and Secure the vehicle
    • Remove the lug nuts
    • Remove the wheel and tire
  2. Applying Penetrating Oil (1:39 in the video)
    • Douse each wheel stud with penetrating oil
    • Let sit
    • Rotate the brake 180 degrees
    • Douse each wheel stud with penetrating oil again
    • Let sit
  3. Removing the Brake Drum (1:57 in the video)
    • Make sure to wear safety glasses
    • Use the hammer to loosen up the brake drum
    • Remove the brake drum
  4. Removing the Brake Hardware (2:24 in the video)
    • Remove the springs using the vice grip or the brake spring tool
    • Remove the spring for the adjuster lever
    • Remove the pins by pushing an turning them with the vice grip
    • Remove theseperator bar to pull the shoes free
    • Put hardware aside if reusing it
  5. Removing the Brake Shoes (5:20 in the video)
    • Use the small screwdriver to drive the clip off the attaching pin
    • Remove the brake shoes
  6. Seperating the Emergency Brake Lever and the Adjuster (6:16 in the video)
    • Push the shoes together by hand
    • Pull off the adjuster and spring
    • Pry the emergency brake lever off with the screwdriver
  7. Cleaning the Backing Plate (6:47 in the video)
    • Clean the backing plate with a wire brush
  8. Inspecting the Adjuster (7:18 in the video)
    • Make sure the adjuster turns freely
    • Make sure all parts of the adjuster turn independently
    • If using a new adjuster, lubricate the threads
  9. Connecting the Brake Shoes (7:56 in the video)
    • Identify the rear shoe by inspecting the lining
    • Attach the adjuster and spring
    • Connect the front shoe to the adjuster and spring
  10. Installing the Brake Shoes (8:48 in the video)
    • Apply grease to slots on back side of shoes
    • Apply grease to the backing plate
    • Put the shoes in place
    • Thread pins through from the back, starting with the front shoe
    • Attatch the springs with the vice grips
    • Put the emergency brake lever behind the rear shoe
    • Attach the spring washer and locking clip
    • Replace the separator bar and lever
    • Attach the hardware for the rear shoe
    • Reattach the springs using the vice grips
  11. Installing the Drum (15:16 in the video)
    • Slide the drum into place
    • Test the fit
    • Run out the adjuster
    • Try the drum again
    • Continue to adjust until the drum drags somewhat
  12. Adjusting the Brakes (16:05 in the video)
    • Remove the rubber plug behind the backing plate
    • Tighten the brakes with a brake spoon
    • Test the fit
    • Back off the adjustment if necessary
    • Apply penetrating oil
    • Replace the rubber plug
  13. Replacing the Wheel (17:16 in the video)
    • Slide the wheel back on
    • Replace the lug nuts
    • Start Tightening the lug nuts
    • Let the vehicle down to the ground
    • Torque the lug nuts to 110 foot-pounds
  14. Testing the brakes (17:29 in the video)
    • Test stopping at low speeds
    • Back up and apply your brakes several times
    • Road test the vehicle

Tools needed for replacement:

    Materials, Fluids, and Supplies

  • Penetrating Oil
  • White Grease

  • Pliers, Cutters & misc Wrenches

  • Lug Wrench
  • Vise Grip Pliers

  • Ratchets & Related

  • Breaker Bar

  • Screwdrivers & Related

  • Flat Blade Screwdriver

  • Sockets - Metric

  • 22mm Socket

  • Specialty Tools

  • Brake Spoon
  • Brake Spring Tool
  • Floor Jack
  • Jack Stands
  • Large Hammer
  • Wire Brush

How-to Video:

(18:01 min)

Tools List:

    Materials, Fluids, and Supplies

  • Penetrating Oil
  • White Grease

  • Pliers, Cutters & misc Wrenches

  • Lug Wrench
  • Vise Grip Pliers

  • Ratchets & Related

  • Breaker Bar

  • Screwdrivers & Related

  • Flat Blade Screwdriver

  • Sockets - Metric

  • 22mm Socket

  • Specialty Tools

  • Brake Spoon
  • Brake Spring Tool
  • Floor Jack
  • Jack Stands
  • Large Hammer
  • Wire Brush




Vehicle Fit

  • 1976-1982 Chevy Blazer Full Size 2WD Brake Drum & Shoe Set Rear
  • 1978-1986 Chevy C10 Truck Brake Drum & Shoe Set Rear for 11-1/8 x 2-3/4 Inch Drum
  • 1974-1986 Chevy Suburban C10 Brake Drum & Shoe Set Rear for 11-1/8 x 2-3/4 Inch Drum
  • 1976-1980 Chevy Van - P Series Forward Control P10 Brake Drum & Shoe Set Rear
  • 1974-1989 Chevy Van G-Series G20 Brake Drum & Shoe Set Rear
  • 1974-1989 Chevy Van G-Series G10 Brake Drum & Shoe Set Rear for 11-1/8 x 2-3/4 Inch Drum
  • 1978-1986 GMC C1500 Truck Brake Drum & Shoe Set Rear for 11-1/8 x 2-3/4 Inch Drum
  • 1976-1982 GMC Jimmy Full Size 2WD Brake Drum & Shoe Set Rear
  • 1974-1986 GMC Suburban C1500 Brake Drum & Shoe Set Rear for 11-1/8 x 2-3/4 Inch Drum
  • 1974-1989 GMC Van G2500 Brake Drum & Shoe Set Rear
  • 1974-1989 GMC Van G1500 Brake Drum & Shoe Set Rear for 11-1/8 x 2-3/4 Inch Drum
  • 1976-1980 GMC Van - P Series Forward Control P1500 Brake Drum & Shoe Set Rear
$140.45
Part #: 1ABDS00029

Out of Stock

Free GROUND SHIPPING

Check Shipping Rates

We're here to help

Customer Feedback

Customer Feedback
"Thanks for the fast reliable service. Great price, and the headlights were as good as oem or better!!! Keep up the good work..."
- Dwuan M.
Read More
Free Shipping!
OR
CALL
TOLL
FREE

888-844-3393

hablamos Español:866-401-3393
SHIPS SAME DAY
For Orders Placed By 5pm Est