Replaces

2004-2005 GMC Envoy XUV Brake Backing Plate for Models with Rear Disc Brakes Rear Pair

Part Details

  • Location: Rear
  • Quantity: Pair

This part replaces:

  • OE # 15158972, 15158973
  • DORMAN 924-208

  • New

This, rear disc brake braking plate set, or brake dust shield or cover kit, is a new aftermarket pair. They bolt to the rear end serve many functions including holding brake parts in place and keeping dust and road debris away from the backside of the rotor. Over time, these backing plates will rust away or become damaged from years of weathering and brake jobs. Why not replace your damaged or rusted out disc brake backing plate now and help bring back the integrity of your brake system!

Specifications:

  • Comes as a PAIR. Will fit both the LH (driver) & RH (passenger sides)
  • Bolts to rear end
  • Made from stamped steel like originals, but coated with rust proof paint
  • Replaces dealer part numbers: 15158972, 15158973
  • Built to strict quality control standards
  • Will need to reuse original mounting hardware
  • Only fits vehicles that have rear disc brakes
  • Will not fit vehicles with rear drum brakes

This rear disc brake backing plate PAIR is a great replacement and has good cost savings over dealer units.

Note:

It is necessary to reuse your original hardware, as new hardware is not included with this item.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. Beginning the Repair (0:05 in the video)
    • This is Part 2 of a two part video
    • Please consult Part 1 for prior instructions
    • Perform the steps outlined in Part 1
  2. Reinstalling the Emergency Brakes (0:35 in the video)
    • Push the emergency brake cable into the cylinder
    • Push the rod into the emergency brake cylinder
    • Push on the emergency brake cylinder cover
    • Clip the emergency brake shoes into place
    • Push the emergency brake spring into place
  3. Reinstalling the Axle (1:56 in the video)
    • Slide the axle in through the wheel, being sure not to drag it on the seal
    • Insert the C-clamp onto the axle at the differential
    • Clean the differential pin
    • Insert the pin into the differential with the whole at the bottom
    • Apply thread-locking fluid to the pin bolt
    • Insert the bolt into the differential
    • Tighten the bolt to between 8 - 10 foot-pounds of torque
  4. Reinstalling the Differential Cover (4:26 in the video)
    • Clean the differential with a cloth rag
    • Clean the differential cover with a cloth rag
    • Apply sealant to the differential gasket
    • Put the gasket in place
    • Put the differential cover in place
    • Start two bolts into the differential cover to hold it in place
    • Start the remaining differential cover bolts into place
    • Tighten the differential cover bolts to 12 foot-pounds in an opposing or star pattern
  5. Refilling the Differential Fluid (5:47 in the video)
    • Remove the plug from the differential with a 3/8 inch drive ratchet and extension
    • Fill the differential with 80W90 differential fluid using a funnel
    • Fill the differential until it starts to leak
    • Put the plug back in
    • Tighten the plug
    • Wipe any grease off the differential
  6. Reinstalling the Brake Rotor (6:34 in the video)
    • Slide the rotor on
    • Put the brake caliper bracket back into place
    • Start the bolts by hand
    • Tighten the bolts to the manufacturer's recommended torque
  7. Reinstalling the Brake Pads (6:53 in the video)
    • Check that the caliper slides move smoothly
    • Clean the brake pad slides with a wire brush if necessary
    • Install the new brake pads into the bracket
    • Put the caliper on
    • Thread the bolts by hand
    • Tighten the bolts to the manufacturer's recommended torque
  8. Reattaching the Wheel (7:28 in the video)
    • Slide the wheel into place
    • Start the lug nuts by hand
    • Tighten the lug nuts preliminarily
    • Lower the vehicle to the ground
    • Tighten the lug nuts to between 100 - 120 foot-pounds in a crossing or star pattern
    • Reattach the center cap
  9. Testing the Brakes (8:04 in the video)
    • Pump your brakes repeatedly until they feel firm
    • Test your brakes at 5 miles per hour and then 10 miles per hour
    • Road test the vehicle

Tools needed for replacement:

    Materials, Fluids, and Supplies

  • Cloth Rags
  • Gasket Adhesive
  • Gear Oil
  • Liquid Thread Locker
  • M10 x 7cm bolts

  • Ratchets & Related

  • 1/2 Inch Breaker Bar
  • 3/8 Inch Drive Ratchet
  • Ratchet
  • Socket Extensions
  • Torque Wrench

  • Screwdrivers & Related

  • Flat Blade Screwdriver

  • Sockets - Metric

  • Complete Metric Socket Set

  • Sockets - SAE

  • Complete SAE Socket Set

  • Specialty Tools

  • A Piece of Pipe (for leverage)
  • Drain Pan
  • Floor Jack
  • Funnel
  • Hammer
  • Jack Stands

  • Wrenches - Metric

  • Complete Metric Wrench Set

  • Wrenches - SAE

  • Complete SAE Wrench Set

How-to Video:

(08:35 min)

Tools List:

    Materials, Fluids, and Supplies

  • Cloth Rags
  • Gasket Adhesive
  • Gear Oil
  • Liquid Thread Locker
  • M10 x 7cm bolts

  • Ratchets & Related

  • 1/2 Inch Breaker Bar
  • 3/8 Inch Drive Ratchet
  • Ratchet
  • Socket Extensions
  • Torque Wrench

  • Screwdrivers & Related

  • Flat Blade Screwdriver

  • Sockets - Metric

  • Complete Metric Socket Set

  • Sockets - SAE

  • Complete SAE Socket Set

  • Specialty Tools

  • A Piece of Pipe (for leverage)
  • Drain Pan
  • Floor Jack
  • Funnel
  • Hammer
  • Jack Stands

  • Wrenches - Metric

  • Complete Metric Wrench Set

  • Wrenches - SAE

  • Complete SAE Wrench Set



This part replaces:

  • OE # 15158972, 15158973
  • DORMAN 924-208

Vehicle Fit

  • 2004-2007 Buick Rainier Brake Backing Plate for Models with Rear Disc Brakes Rear Pair
  • 2002-2009 Chevy Trailblazer Brake Backing Plate for Models with Rear Disc Brakes Rear Pair
  • 2002-2006 Chevy Trailblazer EXT Brake Backing Plate for Models with Rear Disc Brakes Rear Pair
  • 2002-2009 GMC Envoy Brake Backing Plate for Models with Rear Disc Brakes Rear Pair
  • 2002-2006 GMC Envoy XL Brake Backing Plate for Models with Rear Disc Brakes Rear Pair
  • 2004-2005 GMC Envoy XUV Brake Backing Plate for Models with Rear Disc Brakes Rear Pair
  • 2003-2008 Isuzu Ascender Brake Backing Plate for Models with Rear Disc Brakes Rear Pair
  • 2002-2004 Olds Bravada Brake Backing Plate for Models with Rear Disc Brakes Rear Pair
$46.95
Save 36%
List: $73.56 Save: $26.61
Only 4 left in stock
Part #: 1ABMX00063

- Ships Same Day for orders placed by 5 P.M. ET

Free GROUND SHIPPING

Check Shipping Rates

We're here to help

Customer Feedback

Customer Feedback
"Thanks for the fast reliable service. Great price, and the headlights were as good as oem or better!!! Keep up the good work..."
- Dwuan M.
Read More
Free Shipping!
OR
CALL
TOLL
FREE

888-844-3393

hablamos Español:866-401-3393
SHIPS SAME DAY
For Orders Placed By 5pm Est