Replaces

2003-2008 Audi A4 Sedan Power Heated Smooth - Paint to Match Mirror Passenger Side

Part Details

  • Operation: Power
  • Mirror Option: Heated
  • Finish: Smooth - Paint to Match

This part replaces:

  • Hollander 128-51091R
  • OE # 8E1858532AA01C

  • New

This replacement mirror is just what you need to get your vehicle in good looking form again!

Specifications:

  • RH (Passenger Side)
  • Power operation
  • Heated
  • Paint To Match Finish
    • Can be painted to match by buyer or installed as is
  • Folding - manual operation
  • Injection molded plastic housing
  • Replaces dealer part numbers: 8E1858532AA01C
  • Direct replacement
  • Built to strict quality control standards
  • Without memory function

Note: This mirror will be shipped with the cap separated from the housing for painting convenience.

This mirror assembly makes a great replacement and has substantial cost savings over a dealer unit.

Paint To Match Note:

"Paint to match finish" refers to a smooth, paintable surface. This item will be shipped unpainted but will be ready for paint. Final preparation is suggested for better paint coverage and adhesion. 

This part can also be installed without painting if desired. 

Special Note:

  • This mirror is designed to replace an original mirror with these exact options. If you do not have the options listed, there is a possibility that this mirror may not function properly.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. Removing the Door Panel (0:50)
    • Lift the hood
    • Pull back the weatherstrip and disconnect the battery
    • Disconnect the negative battery terminal
    • Pop off the trim button below the door pull
    • Pry off the silver trim piece with a flat blade screwdriver
    • Remove the two screws on the bottom of the door panel
    • Remove the four screws from the top of the door panel
    • Pry out the door panel with a door panel removal tool
    • Pull the door panel up and off
    • Disconnect the door latch cable
    • Disconnect the speaker wiring harness
    • Pry the orange safety clip on the switch panel wiring harness
    • Remove the three T25 Torx screws from the window motor
    • Disconnect the three wiring harnesses from the window motor
    • Remove the T25 screws from the sensor
    • Carefully peel off the water shield
    • Remove the three T35 black screws from the speaker
    • Disconnect the other speaker wiring harness
    • Pull the speaker out, up, and off
    • Pry out the two trim panels at the corner of the door with a flat blade screwdriver
    • Pry off the weatherstrip with needle nose pliers
  2. Removing the Window Frame (5:25)
    • Remove the two T25 Torx screws from the bottom of the regulator
    • Disconnect the side view mirror wiring harness
    • Pull the side mirror wiring from its clips to release it from the door
    • Remove the four T45 bolts from the door frame
    • Remove the black phosphate coated T45 bolt from the door frame
    • Pull the weatherstrip off the side of the door frame
    • Pry out the rubber trim button on the side of the door
    • Remove the T45 Torx bolt below the rubber trim
    • Push the blue regulator motor caps through the door
    • Pull the window frame up and out
  3. Removing the Side Rear View Mirror (7:30)
    • Remove the last two clips to disconnect the window harness
    • Remove the T30 Torx screw from the side view mirror
    • Skip to step 6 unless you need to replace the mirror glass or bezel
  4. Removing the Mirror Glass (8:25)
    • Pry behind the mirror glass and push near the center ring
    • Pry off the defroster leads from the mirror glass
  5. Removing the Mirror Bezel (9:10)
    • Push down on the bezel to unlock it from the clips
    • Release the clip with a 90 degree pick and pull the bezel up
  6. Installing the Side Rear View Mirror (9:54)
    • Remove the old mirror pad from the door frame
    • Guide the mirror into place
    • Tighten the T30 Torx bolt to the side view mirror
    • Clip the mirror wiring harness into the frame
  7. Installing the Window Frame (11:13)
    • Remove the wire harness clips in the door frame
    • Insert the regulator assembly into place
    • Push the power mirror harness into the door
    • Insert the T45 Torx bolt to the side of the door
    • Insert the top T45 bolts to the door frame
    • Tighten the two T25 bolts that hold the window to the regulator
    • Insert the speaker into place
    • Tighten the three T35 black screws to the speaker
    • Insert the weatherstrip into place
    • Push on the rubber trim on the side of the door
    • Push the power mirror harness into place
    • Carefully push the watershield into place
    • Tighten the sensor with two T25 Torx screws
    • Push the speaker wire leads into place
    • Insert the window motor into place
    • Tighten the three T25 screws to the motor
    • Insert the three connectors to the motor
    • Strap in the mirror wiring harness
  8. Installing the Door Panel (15:58)
    • Push the orange safety clip forward on the switch panel wiring harness
    • Push the orange safety clip in while reconnecting the wiring harness
    • Click the speaker wire back in
    • Connect the door latch cable
    • Lift the door panel up into place
    • Push the door panel clips in
    • Insert the four screws into the top of the door panel
    • Insert the two screws underneath the door pull
    • Insert the silver trim panel into place
    • Push on the trim button below the door pull

Tools needed for replacement:

    General Tools

  • Pick
  • Flashlight

  • Pliers, Cutters & misc Wrenches

  • Needle nose pliers

  • Ratchets & Related

  • Ratchet
  • Socket Extensions

  • Screwdrivers & Related

  • Phillips Head Screwdriver
  • Flat Blade Screwdriver

  • Sockets - Metric

  • 10mm Socket

  • Torx Drivers & Sockets

  • T30 Torx Bit
  • T45 Torx Socket
  • T25 Torx Driver

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

How-to Video:

(21:17 min)

Tools List:

    General Tools

  • Pick
  • Flashlight

  • Pliers, Cutters & misc Wrenches

  • Needle nose pliers

  • Ratchets & Related

  • Ratchet
  • Socket Extensions

  • Screwdrivers & Related

  • Phillips Head Screwdriver
  • Flat Blade Screwdriver

  • Sockets - Metric

  • 10mm Socket

  • Torx Drivers & Sockets

  • T30 Torx Bit
  • T45 Torx Socket
  • T25 Torx Driver



This part replaces:

  • Hollander 128-51091R
  • OE # 8E1858532AA01C

Vehicle Fit

  • 2002 Audi A4 Power Heated Smooth - Paint to Match Mirror (8th Vin Digit E) Passenger Side
  • 2003-2008 Audi A4 Sedan Power Heated Smooth - Paint to Match Mirror Passenger Side
  • 2003-2008 Audi A4 Wagon Power Heated Smooth - Paint to Match Mirror Passenger Side
$ 80.95
Save 47%
List: $154.00 Save: $73.05
Part #: 1AMRE02152

Ships Same Day for orders placed by 5 P.M. ET

Free GROUND SHIPPING

Check Shipping Rates

We're here to help

1A Auto Parts

Customer Feedback

Customer Feedback
"Thanks for the fast reliable service. Great price, and the headlights were as good as oem or better!!! Keep up the good work..."
- Dwuan M.
Read More
Free Shipping!
OR
CALL
TOLL
FREE

888-844-3393

hablamos Español:866-401-3393
SHIPS SAME DAY M-F
For Orders Placed By 5pm Est