Replaces
This part doesn’t fit a . Select from parts that fit.
Light Assembly Lifetime Warranty
Frequently bought together
Assemblies may include halogen or incandescent test bulbs that should be replaced before installation.
Features and Benefits
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
The bulbs are for testing and not covered under our warranty. Our warranty applies to the light assembly only.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Hi, I’m Mike from 1A Auto. We’ve been selling auto parts for over 30 years!
Today we're going to be changing the taillight assembly on this 2012 Equinox. If you need any headlight assemblies, taillight assemblies, or any other parts for your car, please check out 1aauto.com.
We're going to start by opening the taillight on the vehicle. You'll see you have two plastic caps covering the mounting bolts for this taillight assembly. I'm just going to pop them open with a flat edge screwdriver and set them aside. These are a 10 mm socket. Now we're going to grab it, and give it a firm pull. Sometimes if it's stuck in there pretty good. You can get these trim tools. 1A Auto sells them online, and you're going to pop it out. Try not to scratch the vehicle. We're going to disconnect first the assembly, the harness, pushing down on this tab and pulling.
To reassemble the taillight assembly, you take the plug from the car and match it up, and you'll hear a click. Line up the guide pins top and bottom, and then firmly push. You're going to have to make sure it's lined up. You might even actually have to hold it down a little. Start it with your finger. I like to leave them a little loose until they're both bottomed out, then I'll give it its final turn. Reassemble the covers, put the tab in at 12 o'clock, push down.
Thanks for watching. Visit us at 1AAuto.com for quality auto parts, fast and free shipping, and the best customer service in the industry.
Tools used
