Replaces

2006-2013 Chevy Impala Power Window Regulator with Motor Rear Pair (High Quality)

Part Details

  • Part Type: High Quality
  • Window Options: with Motor
  • Operation: Power
  • Location: Rear
  • Quantity: Pair

  • New

These power window regulators are just what you need to get your vehicle in good shape again!

Specifications:

  • Comes as a PAIR
    • Fits both LH (Driver Side) & RH (Passenger Side) REAR DOOR
  • Includes the power window motors
  • Replaces dealer part numbers: 20927599, 20927600, 19180070, 19180071
  • Direct replacements
  • Built to strict quality control standards

These power window regulators make great replacements and have good cost savings over dealer units.

Please Note: This High Quality power window regulator is a new aftermarket replacement part that is built to strict quality control standards. It is far superior to the lower quality window regulators which have begun to appear on the internet. Although this window regulator is produced overseas, it was designed in the U.S. and the tooling is owned by a large U.S. manufacturer. That is why we guarantee this high quality window regulator with a superior warranty! If price is your main concern, we do offer the lower price overseas designed and built window regulator in our other listings.

Installation

  • This repair is easier than you may think. You'll find our installation videos helpful. In our experience removing and replacing the door panel is the most involved step in the repair. On most vehicles this only requires removing a few screws and push in clips.
  • You'll get a great feeling of accomplishment after you complete this repair knowing you saved money,and you didn't have to give up your car for a day at the repair shop. Your passengers and other drivers will be amazed.

Fit guaranteed

  • 1A Auto will refund you with no hassle, if this Window regulator does not fit the application stated.
  • You can use your existing hardware and wiring harnesses. This Regulator will install just as your original does. Save time and money.

Quality

  • Be confident this part will work right. Every regulator is tested after assembly to make sure all mechanisms are working correctly.
  • It is important that your new regulator works for a long period of time. The design of this regulator is tested to withstand 10,000 cycles. That is enough to raise and lower your window 3 times per day for 9 years.
  • Nothing is more frustrating than taking your car apart and finding the part you purchased does not fit. You want the part to fit. This design is test fit on an actual door. When you install it, you will have no issues.

Value

  • Windows that don't work can be frustrating. They can also hurt your vehicles value. An inoperable window could mean $200-$500 discounted off a dealer trade value or asking price.
  • Some shops and dealers charge more for parts and repairs when they think you don't know what is involved. Now you can get the value you deserve. Knowing what this repair entails can be the difference between the value of doing it yourself, or the pain of a costly repair bill.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. Removing the Door Panel (0:56 in the video)
    • Pry off the trim piece inside the door handle with a flat blade screwdriver
    • Pry off the trim piece inside the door pull with a flat blade screwdriver
    • Pry off the trim piece at the rear of the door with a flat blade screwdriver
    • Remove the T30 Torx screw inside the door handle
    • Remove the two T30 Torx screws inside the door pull
    • Remove the 7mm bolt at the rear of the door
    • Pry off the window trim piece with a flat blade screwdriver
    • Pry out the door panel with a door panel clip tool or putty knife
    • Lift the door panel up and off
    • Disconnect the latch cable from the door handle with needle nose pliers
    • Pry the door lock switch out of the door panel
    • Carefully peel off the water shield
  2. Removing the Window Regulator (2:46 in the video)
    • Remove the two 10mm bolts that hold the regulator to the window
    • Pull the window up by hand
    • Hold the window in place with painter's tape
    • Disconnect the window motor wiring harness
    • Remove the lower left 10mm bolt from the window regulator
    • Loosen the remaining two bolts from the window regulator
    • Loosen the three bolts from the window motor
    • Pull the regulator out of the door
  3. Installing the New Window Regulator (4:16 in the video)
    • Remove the five 10mm bolts from the old regulator and motor
    • Install the five 10mm bolts into the new regulator and motor
    • Feed the new regulator into the door
    • Hang the regulator and motor by the bolts
    • Insert the lower left 10mm bolt into the regulator
    • Tighten the remaining two 10mm bolts into the regulator
    • Tighten the three 10mm bolts into the window motor
    • Reconnect the window motor wiring harness
    • Secure the wiring with wire ties
    • Remove the painters tape from the window
    • Lower the window by hand
    • Insert the two 10mm bolts that hold the window to the regulator
  4. Reinstalling the Door Panel (6:27 in the video)
    • Put the watershield into place
    • Connect the latch cable to the door handle
    • Push the door lock switch into the door panel
    • Lift the door panel into place
    • Push in the door panel clips
    • Insert the 7mm bolt at the rear of the door panel
    • Insert the T30 Torx screw inside the door handle
    • Insert the two T30 Torx screws inside the door pull
    • Push on the window trim panel
    • Push on the trim piece at the rear of the door
    • Push on the trim piece inside the door pull
    • Push on the trim piece inside the door handle

Tools needed for replacement:

    Materials, Fluids, and Supplies

  • Painter's Tape
  • Wire Ties

  • Pliers, Cutters & misc Wrenches

  • Needle nose pliers

  • Ratchets & Related

  • Ratchet
  • Socket Extensions

  • Screwdrivers & Related

  • Flat Blade Screwdriver

  • Sockets - Metric

  • 10mm Socket
  • 7mm Socket

  • Specialty Tools

  • Door Panel Removal Tool
  • Putty Knife

  • Torx Drivers & Sockets

  • T30 Torx Driver

How-to Video:

(08:00 min)

Tools List:

    Materials, Fluids, and Supplies

  • Painter's Tape
  • Wire Ties

  • Pliers, Cutters & misc Wrenches

  • Needle nose pliers

  • Ratchets & Related

  • Ratchet
  • Socket Extensions

  • Screwdrivers & Related

  • Flat Blade Screwdriver

  • Sockets - Metric

  • 10mm Socket
  • 7mm Socket

  • Specialty Tools

  • Door Panel Removal Tool
  • Putty Knife

  • Torx Drivers & Sockets

  • T30 Torx Driver




Vehicle Fit

  • 2006-2013 Chevy Impala Power Window Regulator with Motor Rear Pair (High Quality)
$110.45
Save 85%
List: $748.68 Save: $638.23
Part #: 1AWRK00841

- Ships Same Day for orders placed by 5 P.M. ET

Free GROUND SHIPPING

Check Shipping Rates

We're here to help

Customer Feedback

Customer Feedback
"Thanks for the fast reliable service. Great price, and the headlights were as good as oem or better!!! Keep up the good work..."
- Dwuan M.
Read More
Free Shipping!
OR
CALL
TOLL
FREE

888-844-3393

hablamos Español:866-401-3393
SHIPS SAME DAY
For Orders Placed By 5pm Est