Replaces

2006-2013 Chevy Impala Power Window Regulator with Motor Front Driver Side (High Quality)

Part Details

  • Part Type: High Quality
  • Operation: Power
  • Location: Driver Side
  • Location: Front

This part replaces:

  • DORMAN 748-172
  • HOLLANDER 125-00119L 617-00183L
  • OE # 10338555 25890045

  • New

This replacement power window regulator with motor is just what you need to get your vehicle in good shape again!

Specifications:

  • LH (Driver Side) FRONT DOOR
  • Replaces dealer part numbers: 10338555, 25890045, 19180071
  • Power operation
  • Direct replacement
  • Includes power window motor
  • Built to strict quality control standards

This power window regulator with motor makes a great replacement and has good cost savings over a dealer unit.

Please Note: This High Quality power window regulator is a new aftermarket replacement part that is built to strict quality control standards. It is far superior to the lower quality window regulators which have begun to appear on the internet. Although this window regulator is produced overseas, it was designed in the U.S. and the tooling is owned by a large U.S. manufacturer. That is why we guarantee this high quality window regulator with a superior warranty! If price is your main concern, we do offer the lower price overseas designed and built window regulator in our other listings.

Installation

  • This repair is easier than you may think. You'll find our installation videos helpful. In our experience removing and replacing the door panel is the most involved step in the repair. On most vehicles this only requires removing a few screws and push in clips.
  • You'll get a great feeling of accomplishment after you complete this repair knowing you saved money, and you didn't have to give up your car for a day at the repair shop. Your passengers and other drivers will be amazed.

Fit guaranteed

  • 1A Auto will refund you with no hassle, if this Window regulator does not fit the application stated.
    • You can use your existing hardware and wiring harnesses. This Regulator will install just as your original does. Save time and money.

Quality

  • Be confident this part will work right. Every regulator is tested after assembly to make sure all mechanisms are working correctly.
  • It is important that your new regulator works for a long period of time. The design of this regulator is tested to withstand 10,000 cycles. That is enough to raise and lower your window 3 times per day for 9 years.
  • Nothing is more frustrating than taking your car apart and finding the part you purchased does not fit. You want the part to fit. This design is test fit on an actual door. When you install it, you will have no issues.

Value

  • Windows that don't work can be frustrating. They can also hurt your vehicles value. An inoperable window could mean $200-$500 discounted off a dealer trade value or asking price.
  • Some shops and dealers charge more for parts and repairs when they think you don't know what is involved. Now you can get the value you deserve. Knowing what this repair entails can be the difference between the value of doing it yourself, or the pain of a costly repair bill.

 

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. Removing the Door Panel (0:55 in the video)
    • Pry off the trim piece inside the door pull with a flat blade screwdriver
    • Pry off the trim piece inside the door handle with a flat blade screwdriver
    • Pry off the reflector with a flat blade screwdriver
    • Remove the 8mm bolt inside the reflector
    • Remove the two T30 Torx screws inside the door pull
    • Remove the T30 Torx screw inside the door handle
    • Pry off the mirror base trim piece with a flat blade screwdriver
    • Pry out the door panel by hand
    • Lift the door panel up and off
    • Pinch the tabs on the cable housing with pliers
    • Remove the cable housing off the door handle
    • Pull the white lock back on the connector and remove the connector
    • Carefully peel off the water shield
  2. Removing the Window Regulator (2:42 in the video)
    • Remove the two 10mm bolts that hold the window to the regulator
    • Raise the window by hand
    • Hold the window in place with painter's tape
    • Disconnect the window motor lead
    • Remove the bottom left 10mm bolt on the regulator
    • Loosen the two 10mm bolts from the regulator
    • Loosen the three 10mm bolts from the window motor
    • Pull the window regulator out through the door
  3. Reinstalling the Regulator (4:35 in the video)
    • Switch over the bolts from the old regulator to the new one
    • Insert one of the bolts into the window regulator
    • Push the regulator into the door
    • Hang the regulator by its bolt
    • Insert the three 10mm bolts into the regulator
    • Insert the three 10mm bolts from the window motor
    • Connect the window motor lead
    • Wire tie the lead to the door and trim it with pliers
    • Remove the painter's tape from the window
    • Lower the window onto the regulator
    • Insert the two 10mm bolts into the window track
    • Reconnect the door switch harness and test the window
    • Disconnect the door switch harness
  4. Reinstalling the Door Panel (7:28 in the video)
    • Put the water shield into place
    • Lift the door panel into place
    • Reconnect the door switch harness and flip the white clip up and over to lock it
    • Connect the latch cables to the door handle
    • Push in the door panel to the window and clips
    • Insert the two T30 Torx screws inside the door pull
    • Insert the T30 Torx screw inside the door handle
    • Insert the 8mm bolt inside the reflector
    • Replace the reflector
    • Re-clip the mirror base trim piece
    • Re-clip the trim piece inside the door pull
    • Re-clip the trim piece inside the door handle

Tools needed for replacement:

    Materials, Fluids, and Supplies

  • Painter's Tape
  • Wire Ties

  • Pliers, Cutters & misc Wrenches

  • Needle nose pliers

  • Ratchets & Related

  • Ratchet
  • Socket Extensions

  • Screwdrivers & Related

  • Flat Blade Screwdriver

  • Sockets - Metric

  • 10mm Socket
  • 8mm Socket

  • Torx Drivers & Sockets

  • T30 Torx Driver

How-to Video:

(09:08 min)

Tools List:

    Materials, Fluids, and Supplies

  • Painter's Tape
  • Wire Ties

  • Pliers, Cutters & misc Wrenches

  • Needle nose pliers

  • Ratchets & Related

  • Ratchet
  • Socket Extensions

  • Screwdrivers & Related

  • Flat Blade Screwdriver

  • Sockets - Metric

  • 10mm Socket
  • 8mm Socket

  • Torx Drivers & Sockets

  • T30 Torx Driver



This part replaces:

  • DORMAN 748-172
  • HOLLANDER 125-00119L 617-00183L
  • OE # 10338555 25890045

Vehicle Fit

  • 2006-2013 Chevy Impala Power Window Regulator with Motor Front Driver Side (High Quality)
$68.45
Save 76%
List: $283.00 Save: $214.55
Part #: 1AWRG01076

- Ships Same Day for orders placed by 5 P.M. ET

Free GROUND SHIPPING

Check Shipping Rates

We're here to help

Customer Feedback

Customer Feedback
"Thanks for the fast reliable service. Great price, and the headlights were as good as oem or better!!! Keep up the good work..."
- Dwuan M.
Read More
Free Shipping!
OR
CALL
TOLL
FREE

888-844-3393

hablamos Español:866-401-3393
SHIPS SAME DAY
For Orders Placed By 5pm Est