Replaces

2003-2008 Honda Pilot Window Regulator Front Driver Side Power with Motor

Part Details

  • Operation: Power
  • Front / Rear Location: Front
  • Side Location: Driver Side

This part replaces:

  • HOLLANDER 125-58996L
  • DORMAN 748-129
  • OE # 72250S9VA02
  • OE # 72250S9VA01

  • New

This replacement power window regulator with motor is just what you need to get your Honda Pilot in good shape again!

This power window regulator with motor features the following specifications:

  • LH (Driver Side) FRONT DOOR
  • Replaces dealer part numbers: 72250-S9V-A02, 72250-S9V-A01, 72250S9VA02, 72250S9VA01
  • Power operation
  • Direct replacement
  • Includes power window motor already assembled to regulator
  • Built to strict quality control standards

This Honda Pilot power window regulator with motor makes a great replacement and has good cost savings over a dealer unit.

Please Note: This window regulator is a high quality aftermarket part that meets or exceeds the performance of the original.  It has been subjected to extensive testing and quality control standards.  That is why we offer this regulator with our superior warranty!

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. Removing the Door Panel (0:43)
    • Pry out the courtesy light
    • Remove the light bulb from the courtesy light
    • Pry off the sail panel
    • Pry up the switch panel with a flat blade screwdriver
    • Disconnect the wiring harnesses from the switch panel
    • Pry off trim piece inside the door handle
    • Remove the two Phillips head screw inside the door handle
    • Remove the Phillips head screw under the door pull
    • Remove the Phillips head screw inside the door pull
    • Pry out the top of the door handle out
    • Disconnect the door lock rod
    • Disconnect the door lock harness
    • Push the door handle into place
    • Pry out the door panel with a door panel clip tool or putty knife
    • Lift the door panel up and off
    • Disconnect the wiring harness from the door panel
    • Remove the three Phillips screws from the speaker
    • Disconnect the speaker wiring harness
    • Carefully peel off the water shield
  2. Removing the Window Regulator (4:27)
    • Disconnect the window motor lead
    • Push the window motor lead clip off
    • Push the yellow clip near the motor lead through the door
    • Loosen the two 10mm bolts that hold the window to the regulator
    • Raise the window by hand
    • Hold the window in place with painter's tape
    • Remove the four 10mm bolts from the regulator
    • Remove the two 10mm bolts from the window track
    • Pull the window regulator out through the door
  3. Reinstalling the Regulator (6:29)
    • Insert one of the bolts into the window regulator
    • Push the regulator into the door
    • Hang the regulator by its bolt
    • Insert the four 10mm bolts into the regulator
    • Insert the two 10mm bolts into the window track
    • Push the window motor lead into the door
    • Remove the painter's tape from the window
    • Lower the window onto the regulator
    • Insert the two 10mm bolts that hold the window to the regulator
    • Connect the window motor lead
  4. Installing the Door Panel (8:35)
    • Connect the speaker wiring lead
    • Tighten the three Phillips screws to the speaker
    • Connect the wiring harness to the door panel
    • Lift the door panel into place
    • Push in the door panel clips
    • Push in the sail panel
    • Connect the lock rod to the door handle
    • Connect the door lock harness
    • Push the door handle into place
    • Tighten the two Phillips head screw inside the door handle
    • Tighten the Phillips head screw inside the door pull
    • Tighten the Phillips head screw under the door pull
    • Connect the wiring harnesses to the switch panel
    • Push the switch panel into place
    • Connect the bulb to the courtesy light
    • Push the courtesy light into place

Tools needed for replacement:

    General Tools

  • Utility Knife

  • Materials, Fluids, and Supplies

  • Painter's Tape

  • Ratchets & Related

  • Ratchet
  • Socket Extensions

  • Screwdrivers & Related

  • Phillips Head Screwdriver
  • Flat Blade Screwdriver

  • Sockets - Metric

  • 10mm Socket


How-to Video:

(12:31 min)

Tools List:

    General Tools

  • Utility Knife

  • Materials, Fluids, and Supplies

  • Painter's Tape

  • Ratchets & Related

  • Ratchet
  • Socket Extensions

  • Screwdrivers & Related

  • Phillips Head Screwdriver
  • Flat Blade Screwdriver

  • Sockets - Metric

  • 10mm Socket



This part replaces:

  • HOLLANDER 125-58996L
  • DORMAN 748-129
  • OE # 72250S9VA02
  • OE # 72250S9VA01

Vehicle Fit

  • 2003-2008 Honda Pilot Window Regulator Front Driver Side Power with Motor
$63.45
Save 54%
List: $137.22 Save: $73.77
Part #: 1AWRG00744

Ships Same Day for orders placed by 5 P.M. ET

Free GROUND SHIPPING

Check Shipping Rates

We're here to help

1A Auto Parts

Customer Feedback

Customer Feedback
"Thanks for the fast reliable service. Great price, and the headlights were as good as oem or better!!! Keep up the good work..."
- Dwuan M.
Read More
Free Shipping!
OR
CALL
TOLL
FREE

888-844-3393

hablamos Español:866-401-3393
SHIPS SAME DAY
For Orders Placed By 5pm Est