2004 Honda CR-V Power Window Regulator with Motor Front Driver Side (High Quality)

Guaranteed to Fit

2004 Honda CR-V

Part Details

  • Product Grade: High Quality
  • Front / Rear Location: Front
  • Side Location: Driver Side
  • Operation: Power

This part replaces:

  • Hollander 125-58969L
  • Dorman 741-302
  • OE # 72250S9AA02

  • New

This window regulator and motor is just what you need to get your vehicle in great working order again!


  • LH (Driver Side) FRONT DOOR
  • Includes the power window motor
  • Direct replacement
  • Replaces dealer part number: 72250-S9A-A02, 72250S9AA02
  • Built to strict quality control standards
  • Motor and regulator come assembled for easier installation

This power window regulator makes a great replacement and has substantial cost savings over a dealer unit.

Please Note: This window regulator is a high quality aftermarket part that meets or exceeds the performance of the original.  It has been subjected to extensive testing and quality control standards.  That is why we offer this regulator with our superior warranty!


  • This repair is easier than you may think. You'll find our installation videos helpful. In our experience removing and replacing the door panel is the most involved step in the repair. On most vehicles this only requires removing a few screws and push in clips.
  • You'll get a great feeling of accomplishment after you complete this repair knowing you saved money, and you didn't have to give up your car for a day at the repair shop. Your passengers and other drivers will be amazed.

Fit guaranteed

  • 1A Auto will refund you with no hassle, if this Window regulator does not fit the application stated.
    • You can use your existing hardware and wiring harnesses. This Regulator will install just as your original does. Save time and money.


  • Be confident this part will work right. Every regulator is tested after assembly to make sure all mechanisms are working correctly.
  • It is important that your new regulator works for a long period of time. The design of this regulator is tested to withstand 10,000 cycles. That is enough to raise and lower your window 3 times per day for 9 years.
  • Nothing is more frustrating than taking your car apart and finding the part you purchased does not fit. You want the part to fit. This design is test fit on an actual door. When you install it, you will have no issues.


  • Windows that don't work can be frustrating. They can also hurt your vehicles value. An inoperable window could mean $200-$500 discounted off a dealer trade value or asking price.
  • Some shops and dealers charge more for parts and repairs when they think you don't know what is involved. Now you can get the value you deserve. Knowing what this repair entails can be the difference between the value of doing it yourself, or the pain of a costly repair bill.


Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. Remove the door panel (0:56)
    • Remove the push clip in the trim piece.
    • Pry up the panel in the back of the door latch.
    • With your flat blade screwdriver, pry up the switch panel.
    • Use your Phillips screwdriver to remove the two Phillips screws in the door latch, and two more under the door pull.
    • Unplug the switch panel.
    • Pry out the door latch and disconnect the power lock switch and the lock rod.
    • Pull the door panel off.
    • Disconnect the rear hatch release.
  2. Remove the regulator (4:29)
    • Peel back your water shield carefully.
    • Remove the two 10 mm bolts securing the window to the regulator.
    • Tape the window up and out of the way with painters tape.
    • Disconnect the wiring harness to the window motor.
    • Unbolt the window regulator and pull it out of the door frame.
  3. Install the new regulator (7:50)
    • Feed the new regulator into the door
    • Bolt the regulator into place with your 10 mm socket and ratchet.
    • Plug in the window regulator motor to the wiring harness.
    • Untape the window and secure it to the regulator by bolting it into the clips.
    • Plug in your window switch panel and test the regulator to make sure it’s working properly.
  4. Put the door panel back on (11:35)
    • Replace the water shield.
    • Plug in the wiring harness and clip the panel into place.
    • Plug in the wiring harnesses for the switch panel and lock switch.
    • Connect the door latch rod.
    • Secure the panel with the four Phillips screws.
    • Snap the door latch, switch panel, and bezel down into place.

Tools needed for replacement:

    Ratchets & Related

  • Ratchet
  • Socket Extensions

  • Screwdrivers & Related

  • Flat Blade Screwdriver
  • Phillips Head Screwdriver

  • Sockets - Metric

  • 10mm Socket

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

How-to Video:

(14:52 min)

Tools List:

    Ratchets & Related

  • Ratchet
  • Socket Extensions

  • Screwdrivers & Related

  • Flat Blade Screwdriver
  • Phillips Head Screwdriver

  • Sockets - Metric

  • 10mm Socket

This part replaces:

  • Hollander 125-58969L
  • Dorman 741-302
  • OE # 72250S9AA02

Vehicle Fit

  • 2002-2006 Honda CR-V Power Window Regulator with Motor Front Driver Side (High Quality)
Save 74%
List: $257.73 Save: $189.78
Part #: 1AWRG00409

Ships Same Day for orders placed by 5 P.M. ET


Check Shipping Rates

We're here to help

1A Auto Parts

Customer Feedback

Customer Feedback
"Thanks for the fast reliable service. Great price, and the headlights were as good as oem or better!!! Keep up the good work..."
- Dwuan M.
Read More
Free Shipping!


hablamos Español:866-401-3393
For Orders Placed By 5pm Est