Replaces

2001-2006 Dodge Stratus Sedan Window Regulator Power Front Pair with Motor

Part Details

  • Operation: Power
  • Front / Rear Location: Front
  • Quantity: Pair

This part replaces:

  • OE # 4878109AF, G, L, 5056029AD,F,G

  • New

These replacement power window regulators with motors are just what you need to get your Vehicle in good shape again!

These power window regulators with motors feature the following specifications:

  • Comes as a PAIR:
    • Includes both the LH (Driver Side) & RH (Passenger Side) FRONT DOOR
  • Replaces dealer part numbers: 4878108AF, 4878108AG, 4878108AL, 5056028AD, 5056028AF, 5056028AG, 4878109AF, 4878109AG, 4878109AL, 5056029AD, 5056029AF, 5056029AG
  • Power operation
  • Direct replacement
  • Built to strict quality control standards
  • Includes power window motor already assembled to regulator
  • Correct for 4 door sedan models only

These power window regulators with motors make great replacements and have good cost savings over the dealer units.

Installation:

  • This repair is easier than you may think. You'll find our installation tips helpful. In our experience removing and replacing the door panel is the most involved step in the repair. On most vehicles this only requires removing a few screws and push in clips.
  • You'll get a great feeling of accomplishment after you complete this repair knowing you saved money and you didn't have to give up your car for a day at the repair shop. Your passengers and other drivers will be amazed.

Fit guaranteed

  • 1A Auto will refund you with no hassle, if this Window regulator does not fit the application stated.
    • You can use your existing hardware and wiring harnesses. This Regulator will install just as your original does. Save time and money.

Quality

  • Be confident this part will work right. Every regulator is tested after assembly to make sure the cables and all mechanisms are working correctly.
  • It is important that your new regulator works for a long period of time. The design of this regulator is tested to withstand 10,000 cycles. That is enough to raise and lower your window 3 times per day for 9 years.
  • Nothing is more frustrating than taking your car apart and finding the part you purchased does not fit. You want the part to fit. This design is test fit on an actual door. When you install it you will have no issues.

Value

  • Windows that don't work can be frustrating. They can also hurt your vehicles value. An inoperable window could mean $200-$500 discounted off a dealer trade value or asking price.
  • Some shops and dealers charge more for parts and repairs when they think you don't know what is involved. Now you can get the value you deserve. Knowing what this repair entails can be the difference between the value of doing it yourself, or the pain of a costly repair bill.

 

Please Note: We are committed to offering the absolute best value for our customers. If you want a highest quality window regulator at a great price, please see our other "High Quality" window regulator listings. If price is your main concern, we are offering this economy style window regulator as well. It is the same one that most internet sellers are offering. While this window regulator is a good replacement, it is not backed by the same warranty as our high quality regulator.

2 Year Warranty

This item is backed by a 2 Year Warranty. In the event this item should fail during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. Removing the Door Panel (0:32 in the video)
    • Pry off the trim piece inside the door pull with a flat blade screwdriver
    • Pry off the trim piece inside the door handle with a flat blade screwdriver
    • Remove the Phillips head screw inside the door pull
    • Remove the Phillips head screw inside the door handle
    • Remove the three Phillips screws at the bottom of the door panel
    • Remove the Phillips screw at the back of the door panel
    • Pry off the trim piece at the front top corner of the door panel by hand
    • Pry out the door panel with a door panel clip tool or putty knife
    • Pry off the mirror base trim piece by hand
    • Lift the door panel up and off
    • Disconnect the door lock wiring harness
    • Remove the clip from the door lock rod
    • Disconnect the window switch wiring harness
    • Use a pair of pliers if any pins are stuck in the aqua clips
    • Carefully peel off the water shield
  2. Removing the Window Regulator (3:18 in the video)
    • Have the window up
    • Remove the six 10mm bolts from the regulator and motor assembly
    • Pull the window down about two inches
    • Loosen the two 10mm bolts that hold the window to the regulator
    • Hold the window, slide the window track forward and take it off
    • Pull the window up by hand
    • Pull the window regulator out through the door
    • Disconnect the window motor lead
  3. Installing the New Regulator (6:05 in the video)
    • Insert one of the bolts into the window regulator
    • Reconnect the window motor lead
    • Push the regulator into the door
    • Hang the regulator by its bolt
    • Insert the six 10mm bolts into the regulator and motor assembly
    • Reconnect the window switch wiring harness
    • Move the regulator into place
    • Slowly lower the window onto the regulator
    • Insert the two 10mm bolts that hold the window to the regulator
  4. Reinstalling the Door Panel (9:44 in the video)
    • Put the water shield into place
    • Lift the door panel into place
    • Connect the lock rod to the door handle
    • Connect the door lock wiring harness
    • Connect the window switch wiring harnesses
    • Push in the door panel clips
    • Insert the Phillips head screw inside the door pull
    • Insert the Phillips head screw inside the door handle
    • Insert the three Phillips screws at the bottom of the door panel
    • Insert the Phillips screw at the back of the door panel
    • Re-clip the trim piece at the front top corner of the door panel by hand
    • Re-clip the trim piece inside the door pull
    • Re-clip the trim piece inside the door handle

Tools needed for replacement:

    Pliers, Cutters & misc Wrenches

  • Needle nose pliers

  • Ratchets & Related

  • Ratchet
  • Socket Extensions

  • Screwdrivers & Related

  • Flat Blade Screwdriver
  • Phillips Head Screwdriver

  • Sockets - Metric

  • 10mm Socket

  • Specialty Tools

  • Flashlight
  • Putty Knife

How-to Video:

(12:11 min)

Tools List:

    Pliers, Cutters & misc Wrenches

  • Needle nose pliers

  • Ratchets & Related

  • Ratchet
  • Socket Extensions

  • Screwdrivers & Related

  • Flat Blade Screwdriver
  • Phillips Head Screwdriver

  • Sockets - Metric

  • 10mm Socket

  • Specialty Tools

  • Flashlight
  • Putty Knife



This part replaces:

  • OE # 4878109AF, G, L, 5056029AD,F,G

Vehicle Fit

  • 2001-2006 Chrysler Sebring Sedan Window Regulator Power Front Pair with Motor
  • 2001-2006 Dodge Stratus Sedan Window Regulator Power Front Pair with Motor
$140.45
Save 76%
List: $582.00 Save: $441.55
Only 3 left in stock
Part #: 1AWRK00253

- Ships Same Day for orders placed by 5 P.M. ET

Free GROUND SHIPPING

Check Shipping Rates

We're here to help

Customer Feedback

Customer Feedback
"Thanks for the fast reliable service. Great price, and the headlights were as good as oem or better!!! Keep up the good work..."
- Dwuan M.
Read More
Free Shipping!
OR
CALL
TOLL
FREE

888-844-3393

hablamos Español:866-401-3393
SHIPS SAME DAY
For Orders Placed By 5pm Est