2001 Pontiac Montana with ABS Front Wheel Bearing & Hub Assembly with Stainless Steel Sensor Wire Clip (Timken)

TIMKEN HUB ASSEMBLY:513121

Specifications:

• Brand New Timken Hub Assembly
• Direct replacement
• Wheel studs already included and installed!
• Replaces dealer part numbers: 7470017, 7470105, 7470143, 7470567, 7470568, 12429204
• Fits RH or LH
• Has ABS sensor w/stainless steel sensor wire clip
• On some AWD models, this will also fit the rear

It is very important when installing to tighten the Hub Nut to 118 foot lbs. Failure to use the correct torque specifications will result in premature failure of the hub.

Note: For vehicles requiring brake opt JL9, this is: 4 wheel Disc Brakes with 4 wheel Anti-Lock Brakes.

Quality

• 1A Auto exclusive 2 Year Warranty.
  • If this hub bearing should fail to provide satisfactory performance you may exchange it.
• You will not have a problem with our product. If you are comparing us to someone selling a brand name product remember brand names are only as good as the company selling them. Both Bizrate.com and The Better Business Bureau recognize 1A Auto as a trusted online seller. You will be pleased with what you find out about us.
• You don't want to be delayed by a defective part. 1A Auto hub bearings are all tested prior to shipping.

Fit guaranteed

• This hub bearing will install just as your original does. You can use your existing hardware.
• Save time and money with this direct fit hub bearing assembly. No trips to the auto parts store or extra time trying to match up and press bearings.
• Hub installation is a degree more difficult than changing a tire on most vehicles.
  1. Jack the vehicle up and support with proper jack stands.
  2. Have a helper hold the brake pedal while you loosen the Axle Shaft Nut. This usually requires a large socket (30mm or larger) and impact wrench.
  3. Remove the brake caliper and brake rotor. Use string or a plastic tie to hang the caliper up and out of the way.
  4. Unplug ABS sensor (if applicable)
  5. Unbolt the hub flange. The hub may come free from the axle shaft easily, if not, use a gear puller or similar tool that pulls on the hub while pushing on the axle shaft. DO NOT try to drive the axle out with a hammer, this could ruin your axle CV joints.

Torque Specifications

• Steering Knuckle to Hub assembly bolts 70 Ft lbs.
• Hub Nut 118 ft lbs.
• Caliper mounting bolts 63 ft lbs.
• Wheel Lug Nuts 100 ft. lbs.

We were able to do a removal and replace on a GM car in about 45 minutes.

Value

• Some shops and dealers charge more for parts and repairs when they think the customer doesn't know what is involved. Now you can get the value you deserve. Knowing what this repair entails can be the difference between the value of doing it yourself, or the pain of a costly part or repair bill.