Replaces
This part doesn’t fit a . Select from parts that fit.
Light Assembly Lifetime Warranty
Frequently bought together
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
The bulbs are for testing and not covered under our warranty. Our warranty applies to the light assembly only.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Don from 1A Auto. I hope this how-to video helps you out, and the next time you need a part for your vehicle, think of 1AAuto.com. Thanks.
In this video, we're going to show you how to service the bulbs as well as replace the taillight circuit board on this 2003 GMC Envoy XL. It's the same part and similar process on the regular Envoys made after 2002. We show you on the passenger side, but the driver side is the same procedure. The items you'll need for this include a new taillight circuit board from 1AAuto.com and a Phillips screwdriver.
Start off by opening your lift gate and removing these two Phillips screws on the inside of the taillight. Pull the taillight out, tilt it back, push the tab on this harness, and disconnect it.
To remove the circuit board to get to the bulbs, remove these three Phillips screws. To service the bulbs, pull the plate out, pull the bulb straight out, and push your new bulb into place. These two are the same process.
If you're looking to replace the taillight circuit board, you can see on the left is the old one; on the right is the new one from 1A Auto. They're identical. All you have to do is swap over the bulbs.
Push the taillight circuit board into the taillight and replace those three Phillips screws. You can see there are two holes here. They should have clips in them. One of them does. One of them's missing. Sometimes they come out with the taillight. Just pull them off that pin on the taillight and push the clip back into place.
Line up these two pins. Push them into those holes. First, reconnect your harness, then push the taillight back into place. Replace those two Phillips screws. You're all set.
We hope this video helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free, 888-844-3393. We're the company that's here for you on the Internet and in person.
