Kit Includes: (1) Rear Passenger Side Interior Door Handle (1) Rear Driver Side Interior Door Handle
Finish: Textured
Item Condition:New
Attention California Customers:
WARNING: This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event that this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
How to Replace Interior Door Handle 2000-07 Ford Focus
How to Replace Interior Door Handles 2000-2007 Ford Focus
Created on:
Tools used
Flat Blade Screwdriver
T20 Driver
1. Removing the Door Panel
Pry off the trim piece inside the door handle with a flat blade screwdriver
Pry off the trim piece inside the door pull with a flat blade screwdriver
Remove the T20 Torx screws from the side and bottom of the panel
Remove the T20 Torx screw inside the door handle
Pry off the trim piece around the door handle
Disconnect the wiring harness from the window switch
Pry off the triangle panel in the corner with a flat blade screwdriver
Remove the 6 1/4 mm bolts from the door pull
Pry out the door panel with a door panel clip tool or putty knife
Lift the door panel up and off
2. Removing the Door Handle
Pull off the door handle
Put the lock switch into the lock position
Pull the latch cable out of the door handle
3. Installing the Door Handle
Put the lock switch into the lock position
Connect the latch cable to the door handle
Slide the door handle into place using the locating tabs
4. Reinstalling the Door Panel
Lift the door panel into place
Push in the door panel clips
Insert and tighten the T20 Torx screws from the side and bottom of the panel
Insert and tighten the T20 Torx screw inside the door handle
Insert and tighten the 6 1/4 mm bolts from the door pull
Push in the trim piece inside the door handle
Push in the trim piece inside the door pull
Push in the triangle panel in the corner
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Mike from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks.
In this video, we're going to show you how to replace a rear inside door handle on this 2003 Ford Focus. The only tools you'll need are a small flat blade screwdriver and a T20 Torx driver. We do it on the driver's side, but the passenger side rear is the same as well.
We're going to first take a small screwdriver. Right back in behind the door handle there's a little round trim piece. Pull that out. Then here, go in behind here, pry that out, and bring that out and down. There are T20 Torx screws: two on the back, two down low, two on the front, as well as one in behind here. Then the 6mm bolts in there. You can use a 6mm socket or an inch socket. Let's speed it up here as I use a T20 Torx bit and remove the six screws around the edge of the door panel. Then one in behind your door handle. Get this off, and then right back here is a little tab.
We need to use your little screwdriver, press the tab down, and disconnect it. This panel comes out. Put your screwdriver under there and pry it out. Work your fingers underneath and unclip it. I'm going to fast-forward as I remove those two inch or 6mm bolts. Now lift your panel, pull the bottom out, lift it up and off the window ledge.
To remove the inside door handle just pull firmly and it comes off. Then, for the cable you have to grip your finger on there and pull it up. Make sure it's in the locked position and it will pull up and right out.
Reinstallation is just a reverse of the procedure. Put it into the locked position, push your cable down, and snap it on. Put this tab in first and snap it on.
To reinstall, push it up and onto the window sill. I'm going to fast-forward. All I'm doing right now is putting all the screws that go along the perimeter and in the door handle. Those are the T20 screws. Putting those in and tightening them up. And last, but not least, make sure you put that triangle trim back in place. Get it in place and push it firmly and it snaps in.
We hope this video helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free, 888-844-3393. We're the company that's here for you on the Internet and in person.
Tools used
T15 Torx Driver
Socket Driver
1/4 Inch Socket
Needle nose pliers
Trim Tool Set
Pick
DHA72169
In Stock
Product Reviews
Loading reviews
There are no reviews for this item.
Customer Q&A
No questions have been asked about this item.
Customer service
877-844-3393
Monday - Friday 8:00am - 9:30pm ET Saturday - Sunday 8:00am - 4:30pm ET
Enter Vehicle Year Make Model
Specify your vehicle's year, make and model to guarantee fit.
Year
Make
Model
Options
Drivetrain
This part doesn’t fit a . Select from parts that fit.