Replaces

1994 Lincoln Town Car Front Driver Side Power Power Window Motor & Regulator Assembly TRQ WRA51420

Guaranteed to fit 1994 Lincoln Town Car

94-97 Lincoln Town Car Window Power Window Reg w/Motor LF

See more Window Regulator >>>

$ 59.95

$90.95

34% OFF

$90.95

34% OFF

FREE SAME DAY SHIPPING

Read 6 REVIEWS

WRA51420

In Stock

This part doesn’t fit a . Select from parts that fit.

Show parts that fit

Orders must be placed by 2pm ET

1A Auto Lifetime Warranty

See more Window Regulator >>>

Frequently bought together

1994 Lincoln Town Car Front Driver Side Power Power Window Motor & Regulator Assembly TRQ WRA51420

$59.95

94-97 Lincoln Town Car Window Power Window Reg w/Motor RF

1994 Lincoln Town Car Front Passenger Side Power Power Window Motor & Regulator Assembly TRQ WRA51421

$59.95

Description

Vehicle Fit

Warranty & Shipping

Part Details

Wiring Harness Included: Yes
Wire Quantity: 2
Installation Instructions Included: Yes
Gear Tooth Quantity: 8
Wiring Harness Length: 15.75 in
Mounting Hardware Included: Yes
Frame Material: Galvanized Steel
Operation: Power
Anti-Pinch Motor: No
Gear Material: Nylon

Specification

Side Location

Driver Side

Location

Front

Item Condition: New

Attention California Customers:

proposition 65 icon WARNING: This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.

Product Reviews

Loading reviews

4.67/ 5.0

Floyd W.

works great, followed your instructions on youtube

Great unit, difficult installation in 96 Town Car

Anthony

The unit is well built and works great. The mounting holes for the motor do NOT line up with the factory unit in my 1996 Lincoln Town car. Do yourself a favor and before you fit the unit into the door, lay a piece of paper over the smooth side and draw yourself a template to drill new holes. Careful placement is critical so the window doesn't hit the motor on the way down. Once you figure out where it will fit without interfering with the lowered window, use the template to drill new holes. I wasn't able to use ANY of the original holes because the new unit is larger (thicker) than the original. Also, the mounting screw holes are way smaller than those shown in the video. 1/4 inch bolts are too large. I had trouble finding 1/8 bolts that were long enough but finally did. The new unit motor and regulator are held together with zip ties. if you remove them before you insert the unit into the door, it is difficult to remove them but if you take them off before the units try to come apa

window is fixed!

took me 2 hours from start to finish, i did cheat and used my chiltons, plus time out for a cold beer. It was a warm day. I've pretty much rebuilt my lincoln with y"alls parts and would gladly recommend 1aauto for any handy person especially since a traditional store charges 3x what you do. will holler when next part is needed. Rob

Works perfectly in 1995 Lincoln Town Car

James

It took twice as long to drill out the old rivets holding in the old regulator/motor assembly, than to install this new TRQ unit! Nice and smooth operation. Mounting holes lined up exactly as expected, and the included nuts & bolts were a plus. The lubrication was just blobbed on in one spot on the regulator guide rail, so plan on spreading that grease around, and then adding more. Look out for confusing (and unnecessary) installation instructions, directing you to install a M6x12mm screw into a hole in the motor that was already plugged with silicone.

Roger

Works great!

Lincoln Towncar 1996 Drivers door perfect fit power window unit

Eugene

Perfect fit and came included with the required mounting bolts, screws, nuts etc.

Customer Q&A

No questions have been asked about this item.