Replaces

1978-1981 Pontiac Firebird Standard Interior Trim T-Top Complete Weatherstrip Seal Kit

  • New

This 11 piece weatherstrip set consists of some of the most accurate reproductions on the market. Made with fine grain rubber and correct molded ends.

This kit comes with:

  • (2) T-Top Hatch Seals
    • For original GM Fisher T-Tops
  • (2) Door weatherstrip seals with correct molded ends and mounting pins
  • (2) Outer Door Window Sweeps
    • Has a Flat chrome bead which is correct for Camaro
    • Will work on Pontiac but will look cosmetically different because those came with a smaller round bead
  • (2) Inner Door Window Sweeps
  • (2) T-Top roof seals
    • For original GM Fisher T-Tops with a single latch
  • (1) Trunk seal

 

Note:

THIS WEATHERSTRIP SET FITS CARS WITH FACTORY GM FISHER T-TOPS AND STANDARD MOLDINGS. THE OUTER WINDOW WEATHERSTRIP HAS A FLAT CHROME BEAD WHICH IS CORRECT FOR CAMARO. THESE OUTER WEATHERSTRIPS WILL WORK ON THE PONTIAC BUT ARE DIFFERENT FROM THE ORIGINAL WHICH HAVE A SMALLER ROUND BEAD. THIS SET IS ALL REPRODUCTION. THE SEALS ARE THE MOST ACCURATE AND HIGHEST QUALITY REPRODUCTION AVAILABLE.

Wear and Tear

This item is backed by a 60-day warranty against defects in materials and workmanship under its intended use. The warranty does not cover normal wear and tear. Please keep your invoice for proof of this warranty.

  1. Dry Fitting the Trunk Weatherstrip (1:00)
    • Remove the trunk adhesive
    • Remove any rust or scale
    • Insert the weatherstrip with the thicker side down in
    • Push the lip so it sits on the top of the trunk, then push the lip down in
    • Use a plastic spoon or trim tool to keep from scratching
    • Repeat this process as you fit the weatherstrip around
    • Cut a quarter inch beyond where the seam is with a razor blade to match the weatherstrip
    • Close the trunk to check the weatherstrip placement
  2. Installing the Weatherstrip (5:40)
    • Pop open the trunk
    • Loosen the striker or latch bolts and slide the striker or latch up or down to adjust the trunk
    • If the weatherstrip keeps the trunk from closing, adjust the trunk so it sits on the weatherstrip
    • After the weatherstrip has pressed down, adjust the striker or latch back in place
    • Remove the weatherstrip
    • Line the outside of the trunk channel with painter's tape
    • Place adhesive inside the line of the trunk channel near the tape
    • Place adhesive on the side of the weatherstrip that will touch down in the channel
    • Insert the weatherstrip into place
    • Repeat the process for the rest of the weatherstrip
    • Trim off any excess near the end
    • Remove the painter's tape

Tools needed for replacement:

    General Tools

  • Razor Blade / Gasket Scraper
  • Wire Brush
  • Heat Gun

  • Materials, Fluids, and Supplies

  • Painter's Tape
  • Plastic Spoon

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

How-to Video:

(12:06 min)

Tools List:

    General Tools

  • Razor Blade / Gasket Scraper
  • Wire Brush
  • Heat Gun

  • Materials, Fluids, and Supplies

  • Painter's Tape
  • Plastic Spoon




Vehicle Fit

  • 1978-1981 Chevy Camaro Standard Interior Trim T-Top Complete Weatherstrip Seal Kit
  • 1978-1981 Pontiac Firebird Standard Interior Trim T-Top Complete Weatherstrip Seal Kit
$ 315.95
Save 40%
List: $523.95 Save: $208.00
Part #: 1AWSK00102

Ships Same Day for orders placed by 5 P.M. ET

Free GROUND SHIPPING

Check Shipping Rates

We're here to help

1A Auto Parts

Customer Feedback

Customer Feedback
"Thanks for the fast reliable service. Great price, and the headlights were as good as oem or better!!! Keep up the good work..."
- Dwuan M.
Read More
Free Shipping!
OR
CALL
TOLL
FREE

888-844-3393

hablamos Español:866-401-3393
SHIPS SAME DAY M-F
For Orders Placed By 5pm Est